Navara D21 Bull Bar

[Monaro Pete]

Would a 2001 D22 bull bar fit a 2003 Terrano?

Thanks

 

[Monaro Pete]

One that looks like this

 

[terranosaurusdoug]

Mmmmmm shiiiiiny :homer

Can you get measurements of the brackets?, I'm sure you could make it fit, might take a bit of time but it's gotta be better than filtering melted freezer ice through a sock :augie

 

[Lazy-Ferret]

I'd make it fit... Nice...

I used some 3/8" thick Aluminium plate to effectively move the chassis holes and fix the WD21 bull bar to Suz's T2 as the WD21 bars were wider than the T2 chassis. I then made up Stainless straps to run from the top bar, through the slots in the bumper, and after putting a couple of Rivnuts into the metal apron under the bumper, behind the grill, fixed the straps to them, so stabilise the bar so the spots didn't bounce.

 

[Monaro Pete]

Thanks for the replies :thumb2

Altering the brackets isn't a problem really.

I should've explained better............. I don't want to purchase it only to find that it's too wide for the overall front of the truck, as it wraps around the headlights. This would look very silly :lol

It is for a D21 Navara not the 22 as this bar is off an import.

My mistake for pressing the wrong button

 

[terranosaurusdoug]

I reckon it will fit, the d21 are narrow like the terrano.

 

[Lazy-Ferret]

OK, I am making a few assumptions here, but looking on Google, the front end of the D21 Navara, looks almost identical to our WD21.

The wd21 front is exactly 5 foot wide, and the wings go straight back, where as the T2 Mk3 is 5 foot 4 inches wide, from the outside edge of the indicators on the wing and then the wings actually get wider heading back to the wheel arches...

So to be honest, I think you would be taking a gamble that would not pay out.. Shame though, as I think it would look good.

 

[elty001]

Looking at the lower mounting brackets​ it picks up on the bottom of the chassis rails where the pig tail recovery hook mounts.
If you can get the width of it from the seller it will give you an Idea if it will fit.
Also need to know the distance from the lower mounting to the back of the bar to see if it will clear the bumper.