milner manual hubs

Nissan 4x4 Owners Club Forum

Help Support Nissan 4x4 Owners Club Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

eboy

Well-known member
Joined
Feb 24, 2009
Messages
95
Reaction score
0
hi all
got some manual hubs from milners today to replace my autos
in the down loads it shows fitting avm ones has anyone fitted milners ones as i had trouble this afternoon fitting them do i remove all the washers and fit the circlip to the outer slot on the drive shaft as they dont fit flush with the hub other wise thanks in advance
eboy
 
Can't remember how many washers I had to remove on mine but you do need to leave the circlip on there to stop the drive shaft pulling out of the hub. Only thing that Plank say's he would change is not as much grease as the download shows. Mine was AVM from Milners and pretty much straight forward. Make sure you remove the brake ring from the end of the drive shaft not just the outer part and spring. Think there was a splined washer that I had to remove too but it's 5 years of trouble free hub's since I replaced mine.

Jim

PS Plank is the expert on these
 

Latest posts

Back
Top