Manual hubs

[Fishcom]

I have just washed my Mav & noticed that I have a centre cap missing off my front n/s wheel: On closer inspection & after removing my o/s wheel, I appear to have AVM manual hubs which until now I was blissfully unaware of...
So far so good, but neither side has it's cover (the bit to turn to lock/unlock), however I can stick my fingers in & turn the inner bit to lock & unlock the hubs, which appears to work.
The upshot of this is, either does anyone have a knackered pair I can scavenge the bits from or will it do no harm to leave them as they are? (I can supply pics if it helps)
I also have a pair of auto hubs in good order if anyone's interested in a deal of some sort..
Thanks

Part 2: Just been out to double check on some muddy bits: They appear to be in 4wd all the time, despite turning & clicking into place each end: Any clues?

 

[jims-terrano]

I would say bite the bullet and purchase a brand new pair if you can. I have AVM's and the centre caps do not fit either, I was going to make a nice neat hole in the centre caps for the AVM's to fit through but I aint got round to it.

Jim T

PS have you seen the workshop in the downloads section regarding fitting AVM's, you may be able to see which bit is missing from yours.

 

[(RIP) PLANK]

tyr milner off road i am sure they do service kits for the manual hubs they may be seized on! so they may do sapres, but they aren't all thet exspensive so might be worth a new pair?

 

[georgegyo]

auto hub

Hi there.i am interested to buy your auto hub.How much you wont for them?Thanks George