LED & CREE type bulbs

Nissan 4x4 Owners Club Forum

Help Support Nissan 4x4 Owners Club Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

macabethiel

Well-known member
Joined
Aug 20, 2008
Messages
4,412
What's the view of our community of the LED & CREE type bulbs that you can use to replace interior festoon bulbs and your standard tungsten fillament type side, stop & tail type bulbs ?

Are they worth the bother in terms of better illumination etc ?
 
What's the view of our community of the LED & CREE type bulbs that you can use to replace interior festoon bulbs and your standard tungsten fillament type side, stop & tail type bulbs ?

Are they worth the bother in terms of better illumination etc ?

Did a before and after on the Terrano rear plate, I'm sure there was a member on her making them and I brought a few and they are still going strong

Left bulb is the LED and right is the normal filament bulb
20141017_200247.jpg


Both LED's in :thumb2
20141017_231514.jpg
 
Last edited:
Inside the car I have found the COB LEDs seem the best as they seem less directional, so give a better light. I have replaced the bulb in Suz's cubby hole (ohh err) and my main courtesy light, but did take a bit of modding to fit them.

Sent from my SM-T705 using Tapatalk
 
Inside the car I have found the COB LEDs seem the best as they seem less directional, so give a better light. I have replaced the bulb in Suz's cubby hole (ohh err) and my main courtesy light, but did take a bit of modding to fit them.

Sent from my SM-T705 using Tapatalk

They sound interesting Clive!!! You got any links?
 
Number Plate Illumination looks good

Banshee,

That looks quite impressive on the number plate I think I will start with the number plates first and see how it goes.
 
I have found cheaper LEDs are not long lived and soon start to flicker. I bought some festoon bulbs from Sweety which have been fine as interior at the very back but not done anything with the fron interior lights.
I fancy playing with a pcb and some white LEDs that I have for the high level brake light. Would like some kind of good led lamp for the boot area.
 
Sorry didn't read all f the post
But they might be of interest.
I thought of replacing the full interior light, but the switch may pose a problem :nenau
 
i have fiited these t replace my interior lights and are very bright as my terrano had no front map lights so fitted the unit and works fine on the door switches etc:thumb2
 
My Number Plate Light Bulbs are Capless 12v 5 w type 501

Obviously they will need to be fitted the right way round but is there an LED version of a Capless Bulb ?

Any links welcome especially if used by a member.
 
Obviously they will need to be fitted the right way round but is there an LED version of a Capless Bulb ?

Any links welcome especially if used by a member.

Oh yeah there is I'm sure just don't know what it is :nenau
 
Yes you can get cap less type bulb led things. Fleabay list loads but a lot are the cheapo that don't seem to last two minutes.
 

Latest posts

Back
Top