Fuse

[supergnome]

I have no reading on the following, fuel gauge, temperature, trip meter,ext thermometer, speedo + odometer and tacho.
Is it a fuse and where? David.

 

[makeitfit]

I seem to remember there's a fault or two on the new type electrogizmo dash.
Dry joints on the plastic circuit board perhaps.
I assume the car is working appart from the display

 

[Banshee]

I have no reading on the following, fuel gauge, temperature, trip meter,ext thermometer, speedo + odometer and tacho.
Is it a fuse and where? David.

This sounds familiar!!!!!!
is this the cluster issue guys?

 

[supergnome]

Everything else working. Went I think when I zeroed the trip meter.

 

[makeitfit]

Try a bigger hammer :augie

 

[96terrano]

Try a bigger hammer :augie

that's the best option:sly

plan B could be they were dry solder joints, so when you pressed the button it could of loosened the joints just enough, can be fixed, i posted a how to up somewhere :thumb2

 

[Banshee]

that's the best option:sly

plan B could be they were dry solder joints, so when you pressed the button it could of loosened the joints just enough, can be fixed, i posted a how to up somewhere :thumb2

like the one where you glue gunned all the inside of your wiper relay :lol:lol

 

[bry]

I have no reading on the following, fuel gauge, temperature, trip meter,ext thermometer, speedo + odometer and tacho.
Is it a fuse and where? David.

I have had this problem twice on my 2001 T2 se.Both times i just removed each fuse,in the fuse box near drivers right leg.Replaced them all.And everything worked as it should(Apart from the digital dash,common fault)So i reckon its a dry joint on the fuse box.

 

[supergnome]

Sorted.......Manual shows diagram and is fuse 16 10amp. Looked OK but when replaced dials came up! Half a tank of cooking left. Yes Bry, I might replace a few more. Thanks, David.