laurieash
Well-known member
- Joined
- Aug 10, 2010
- Messages
- 423
Hi guys had a few jobs to do on Terrano today, fitted new top ball joint very easy all bolts came out :thumb2 then fitted front Brake callaper supplyied
By ryan Terrano 96 thanks for that, another easy fit also, so the last job of the evening was the rear anti roll bar link. Left the easy job for last, what a pig it was top bolt started to undo then stopped, so a bit of heat on job nearly set fire to motor
rubber gromits,so panic over got bolt/nut moving, then started to fit new one top on ok, then fitting bottom ball joint would no tighten up, tryed mole grips to hold it to bar,clamps, mest about for about 15mins trying to sort.bugger was my thinking,or words something like that.
so closer inspection needed glasses on,:doh there was two flat edges to put a spanner on so you could tighten the locking nut. what a Dickhead:naughty
so the longest job was the shortest. so all jobs done piece of mind.
Laurie Ash.
By ryan Terrano 96 thanks for that, another easy fit also, so the last job of the evening was the rear anti roll bar link. Left the easy job for last, what a pig it was top bolt started to undo then stopped, so a bit of heat on job nearly set fire to motor
rubber gromits,so panic over got bolt/nut moving, then started to fit new one top on ok, then fitting bottom ball joint would no tighten up, tryed mole grips to hold it to bar,clamps, mest about for about 15mins trying to sort.bugger was my thinking,or words something like that.so closer inspection needed glasses on,:doh there was two flat edges to put a spanner on so you could tighten the locking nut. what a Dickhead:naughty
so the longest job was the shortest. so all jobs done piece of mind.
Laurie Ash.
