Cubby Hole below heater controls

[Banshee]

Mine seems to have given up and wont clip back in after having the weight of my CB, SWR meter and 3 way 12v adaptor wedged inside it for a while

It clips back in but the minute I hit a speed bump it falls back off again, does anyone have a replacement one in the weird grey/blue colour or is there a simple way of fixing this without permanently securing it in place as I'll want to run some wires through there at some point?

I was thinking of maybe 2 small hinges either side?

http://www.ebay.co.uk/itm/2-Small-B...rafts_EH&var=460196578220&hash=item258109d0b9

You guys ever had this?

 

[makeitfit]

Yep and the easy fix is some of those wide headed body trim screws. Plenty up the scrappy
Just screw the outside of the cubby at the clip points. I only needed two on mine and it's been bounced around all ways up and side ways :thumbs

 

[Banshee]

Yep and the easy fix is some of those wide headed body trim screws. Plenty up the scrappy
Just screw the outside of the cubby at the clip points. I only needed two on mine and it's been bounced around all ways up and side ways :thumbs

Give me an example of a body part that would have those screws?

 

[makeitfit]

Like the ones that screw down the plastic door step sill cover things
If they're not to grubby :lol
I think there's some under the dash too

 

[Banshee]

Like the ones that screw down the plastic door step sill cover things
If they're not to grubby :lol
I think there's some under the dash too

The ones that hold the sill plastics down are all plastic and aren't very tough at all, I remember removing them to get my MOT welding done

 

[makeitfit]

Must be the back door plastic trim then :augie they're somewhere on there :lol

 

[bry]

Mine seems to have given up and wont clip back in after having the weight of my CB, SWR meter and 3 way 12v adaptor wedged inside it for a while

It clips back in but the minute I hit a speed bump it falls back off again, does anyone have a replacement one in the weird grey/blue colour or is there a simple way of fixing this without permanently securing it in place as I'll want to run some wires through there at some point?

I was thinking of maybe 2 small hinges either side?

http://www.ebay.co.uk/itm/2-Small-B...rafts_EH&var=460196578220&hash=item258109d0b9

You guys ever had this?

Ya might want to ask Jud750.He seems to good with that sort of thing