Clutch pipe leak

[bonesXU1]

I have a slight leak near the rear axle and I want to blank the pipe off at the T peace near the bellhousing and was wondering what size and thread is needed for a blanking plug?

 

[zippy656]

My " little man" used a ball bearing

 

[bonesXU1]

My " little man" used a ball bearing

Interesting way of doing I suppose, but I can't say I have any of them kicking about the garage. I trying not to take it apart to see what size and thread it is as I use it as my daily driver just in case I hit problems.

 

[Banshee]

Interesting way of doing I suppose, but I can't say I have any of them kicking about the garage. I trying not to take it apart to see what size and thread it is as I use it as my daily driver just in case I hit problems.

Hi Mate

Glad to see you back, I have a winch and tray and should be fitting soon and still going to copy yours as much as I can :thumb2 Did your truck ever have Air Con? Doug had to remove his to fit his winch copying your design somewhat too.

 

[Mav96]

I have a slight leak near the rear axle and I want to blank the pipe off at the T peace near the bellhousing and was wondering what size and thread is needed for a blanking plug?

I cannot remember the size as I was in rush but i used a gas blanking plug with ptfe.

 

[macabethiel]

Blanking off pipe - is it a breather ?

I have a slight leak near the rear axle and I want to blank the pipe off at the T peace near the bellhousing and was wondering what size and thread is needed for a blanking plug?

Is this a breather pipe ?

I would have thought if it is there is a risk that a pressure build up in the differential might result in oil passing the axle seals onto the rear brakes ?

 

[R1cho]

Is this a breather pipe ?

I would have thought if it is there is a risk that a pressure build up in the differential might result in oil passing the axle seals onto the rear brakes ?

Sounds like he's talking about the clutch pipe we all blank off, i swapped the box for apiece of brake flexi it was same thread and straight swap over, only took a few minutes to do