are thease the bolts i need?

[zippy656]

http://www.namrick.co.uk/browse.asp?PCID=9


M12 1.25mm Pitch 60mm long so i can refit the pig tail too??

 

[Terranosaurus]

Sounds right but don't know for certain - you've got te other pair out.

Are the M12 - ie nominal 12mm diameter

Are the 40mm long

Are they 1.25mm pitch - ie 4 treads per 5mm or 8 threads per 10mm/1cm

 

[zippy656]

normal M12's nearly fitted. so thats right, just the pitch was rong. the ones i took out are a lot finer, and a local man just looked and said M12 1.25 pitch, we dont have any..sorry mate...

looking at the site. .95p each plus vat. cant see nissan haveing them for same or less...

 

[Jocky]

Have you asked Nissan for the bolts?

I got 2 off them for my ABar and it was only £2 or so, and they ordered them.

 

[zippy656]

will call tomorrow

tar

 

[P40MRT]

My Avenger A bar has been on for about 5 months and 5000 miles, and I never did get round to buying the extra pair of bolts! Just one each side at the bottom, and then the two little 'straps' between grille and bumper...

 

[rustic]

The bolts are the same as Citroen Picasso wheel bolts, M12 x 1.25 as far as I am aware. When I fitted locking wheel bolts to picasso, I noticed they were the same as the front tapped holes in the maverick, as I was thinking of fitting a front tow bar at the time. Still not fitted one yet though.
May be next year...

 

[zippy656]

i dont have one that uses the two little 'straps' between grille and bumper...


just the 4 bolts

 

[ssteve]

normal M12's nearly fitted. so thats right, just the pitch was rong. the ones i took out are a lot finer, and a local man just looked and said M12 1.25 pitch, we dont have any..sorry mate...

looking at the site. .95p each plus vat. cant see nissan haveing them for same or less...

m12 has 1.75 as std pitch see below
http://www.boltdepot.com/fastener-information/Measuring/Metric-Thread-Pitch.aspx

ssteve

 

[Terranosaurus]

m12 has 1.75 as std pitch see below
http://www.boltdepot.com/fastener-information/Measuring/Metric-Thread-Pitch.aspx

ssteve

Yes it does but Japanese manufacturers use a lot of metric fine hence the question - if you read the thread zippy has already tried a std M12.

 

[ssteve]

Yes it does but Japanese manufacturers use a lot of metric fine hence the question - if you read the thread zippy has already tried a std M12.

it must be JIS then
ssteve

 

[zippy656]

oh yes tryed that, on my back with the A Bar in one hand the other holding the spacers and the other holding my sockets..

yep ive got three hands!

 

[scott301004]

I have used M12 X 1.25mm pitch with the front tow bars

 

[zippy656]

well your the man whod know..

thanks scot..

 

[scott301004]

and i got them from namrick as they are pretty good with delivery and price

 

[zippy656]

thats one of the searches ive found with google..