Search results

I have mentioned this before but, nobody came up with an answer so, I'm trying again! I have a very infrequent clutch problem ( happened twice in 6 months). I'll be driving along happily and suddenly, the clutch will start slipping in whatever gear I happen to be in. The clutch pedal goes rock...

Wonder if anybody knows what this problem is caused by? Clutch on my Terrano is normally fine, apart from a little pedal drop. The other day, I went on a run (about an hour) when I noticed that the clutch pedal had gone really hard when changing gear. Then the clutch started to slip in all...

Anybody got one of these or know where I can get one (apart from Nissan). It needs to fit a 40mm aperture. I am trying some breakers too.

I need a jack handle for my Terrano please....... :-)

My son has just bought a mav for not very much money. It has a peculiar fault where it starts up straight away, though pretty smokey, then, after the engine is fully warmed up, it's as if the turbo cuts out and you cannot rev the engine over around 3,000 rpm and the speed drops fairly...

Hi, I have a terrano 11 van, which, as far as I can make out, will not be affected by the new emission zone regs coming in next Jan. BUT, and this a BIG BUT, I don't trust these buggers one bit! It says on their site that the information might not be correct so..... can anybody tell me what the...

Hi, all. On my 1997 Terrano, the slide control which moves the hot/cold air from windscreen to footwell etc. appears to be broken. it just slides about and although it won't actually fall out, it feels very loose [after being very stiff] how difficult will it be to investigate this problem? i am...

My Terrano has suddenly become very sluggish when trying to start. Discovered today that someone has done a real bodge job and repaired the positive cable at some point in the past. They'd soldered [very badly] a couple of inches of much thinner cable to the positive cable just where it comes...

Hi, does anybody know the best way to get at the starter motor to replace it? It looks like a real pig of a job to me :(

help! have a lot of water coming into the driver's footwell. anybody have any pointers as to where to start investigating before i start dismantling everything? all help appreciated 8)