Search results

Hi chaps, Sorry if this has been posted many times (I would think it has) but would a 2 inch lift allow for tyre sizes around 31 inch.? My suspension is old and tired so at some point I will be replacing it. It would be nice to add a small lift and go for some A/T tyres. Don't want to go silly...

not sure if this would apply but in this hot weather I put frozen bottles of water in the rabbit hutches. They lie against them if it gets too hot and also lick the outside to cool down.

Do you have the dip stick.?

I shall have a look at the flange you mentioned. The thrust bearing is still doing the rumbling so I don't think it would be that. I think I will pull the gearbox and sort the thrust bearing anyway, it drives me mad. Might as well fit a new clutch while I'm there and sort out the spongy pedal...

Defiantly not props etc. The thrust bearing is a bit noisy so it may well be that. Odd nose though for one, not a rumble as normal.

Hi all, I have a squeaky noise (I think thats the best way to describe it) coming from somewhere in the transmission. It makes the noise if you let off the throttle when driving but goes if you push the clutch in or go back on the throttle. Is there any obvious faults on these before I start...

That's very cool.

Personally i would save up a little more and buy a slightly more expensive one. Much better to use and better results. I have a Clarke 135TE Turbo MIG Welder. Its ok but would be better with a variable control rather than just 2 high low buttons. I had to get one quick as my other died but am...

Nice one. Being prepared for problems is the way to go. So many people go out in the bad weather in their car without any prep. All it takes is a puncture or breakdown and it can all go wrong, especially in the winter weather of the last couple of months

Welcome to the club :thumb2

Happy Zombie Jesus day. Not much going on here, kids are working so need lifts. Me and the boss have today free so might go for chips and ice cream (not together) by the water

Nice photo's :thumb2

That must be a nightmare. Would a carefully aimed air rifle help. :D Am i right in thinking the new MOT regs are clamping down on the retro fitted ones now.?

That sounds a real interesting project. Be good to see some photo's :thumb2

Clocks have done their thing so i'm happy :D off to the workshop for me today, way too much to catch up on, been getting side tracked lately

They are terrible things. Half the time you are flashing them thinking they have left their high beam on. I have been left with squinty eyes for a few seconds after, so it surely can't be safe.

Cheers Jim. I'll search it out

I like that. Has anyone made a hinged table on the rear door of the terrano ?

Welcome :thumb2

I would give an XJ a good look all over. They aren't a separate chassis so no worries with that. I think the later ones, '97 onwards (but don't quote me on that) are galvanised and less prone to rust. All of the ones i have had have been rust free. The petrol motor is bullet proof. The diesel...