Search results

My manual only shows the TDi version, Rick

I will not be able to look until the WE as the Mrs is always out in her motor, Rick

Yes close enough to pop over sometime, we can then stick your motor on the hoist and give it a once over, PM me for my phone number, Rick

Hi and welcome to the club, are you anywhere near Bexhill, Rick

In my experience pump timing does not dramatically alter power, what it does effect is exhaust gas temp, similarly the TPS will only effect gear shit patterns rather than power as being a mechanical pump it cannot alter anything in the pump, my VE pump is on my RD28t inline six and has been...

Hi and welcome, first thing to check is the pressure regulating valve, this is located at the front top of the pump and is recognised by the fact it has a round head with two flats on it, a 10mm spanner fits but you will be lucky if you can get an open end spanner on it, once you have this out...

Here is a pic of the spool, note the bit of wire, that is holding the spring tension, what you do is pull the belt all the way out and jamb the spool, then push the belt back through the slot till you can get at the plastic pin that goes through the stitched loop in the belt, remove the pin then...

Belts come it 2 colours, belt colour and trim colour (the bit on the pillar above your shoulder) if you are not fussed about that then I can probably find you a belt to replace yours, I would advise not to unplug the electrical connector on your unit and just do the belt change in situ, if you...

The only one I have with a pre tensioner is minus its belt, which tells me they are replaceable, will have to look at Mrs motor tomorrow and see if I have a belt suitable, they are not too difficult to change, Rick

I doubt the mounting will be the same on a Patrol, I will take a pick of what I have and post it tomorrow (Monday) Rick

The 3 will have pre tensioners and yes you need a drivers belt, the others will not fit, I have a few belts but not a drivers pre tension one, however the belts can be changed on the spool but it is a bit tricky, Rick

Have you put a hammer over the rest of it? I would be very surprised if the rot was confined just to those places, for a garage to do that work alone I would think you will not see any change from £750. I would be seriously considering scaping it, not what you wanted to hear I know but that...

Hi Rob I have had this at odd times and was due to one door not shutting properly which seems to effect the electrics into thinking the door is open, I cannot check this on the Mrs motor as it is a 2002 and different, but when Pete comes into the yard next I will try and replicate it on his, Rick

I am still here with my trusty Patrol, Rick

Yes just done just that, a new gasket, due to a few months ago coming home from the wood boiled up due to rad clogged with mud, limped home with regular water stops but after sorting the rad all seemed good, but ordered a new gasket anyway as was sure to need it, well last week it failed as I...

Handy to know thanks, although I do not use the stuff, Rick

There is light at the end of the tunnel Jim, I might get to see it maybe even to work on it, he is not too far from me, Rick

Those on Ebay are overpriced rubbish, thank you Jim I will contact your mate but doubt the tank will be any better than the one I have, as it is for the Mrs motor I will probably get one made out of SS which will be cheaper than the Ebay rubbish but rectangular and a bit smaller, but that is not...

Yes and he does not have one, Rick

Hi all if anyone has a good Terrano tank I need one, Rick