Milner Off Road

Banshee · 25-03-2018, 20:51

Now people know that I have strong feelings about Milner Off Road now after all of the issues I've had with them in the past.

I swore to myself that I would never use them again and have publicly said this on the forum.

I was looking for a set of front anti roll bar "D" clamp polybushes last week, I couldn't find a set on eBay

they were all rubber ones and the only 1 polybush listing I could find was almost £30

Knowing that Milners used to stock these I headed over to their page and there they were, reluctantly I placed an order.

3 days later this is what turns up in the post

I rang them up and went OFF!!!!! The guy on the end of the phone was at least apologetic and did promise that I'd get the correct part a day later which did in fairness turn up.

Another quality transaction with our friends in Derby

Jay666d · 25-03-2018, 21:06

They must just have your number dude!

jims-terrano · 25-03-2018, 21:22

That’s nuts

No seriously that is not good at all is it mate but proves exactly what we have said for a while.

terranosaurusdoug · 25-03-2018, 22:54

I ordered some bits from them once, it was a smooth transaction and quite a pleasurable buying experience overall

macabethiel · 25-03-2018, 23:16

I too have had a mixed experience with M.O.R. but they were a cheap source of Polybushes for my old r3mR and very good fully synthetic grade ATF.

The best bit was that the Polybushes came with bolts & washers. Not so impressed with the "Boshi"brand of filters.

Except for once when they sent me the wrong part I have always driven there even though its a 25 mile each way run.

RJL Services · 26-03-2018, 09:09

i have never had any problems with them always got want i needed and at a good price when i ordered my brake caliper pins they were actually genuine nissan ones i got too i still continue to use them

25-03-2018, 20:51	#1
Banshee Moderator Join Date: Jul 2012 Location: West Midlands Vehicle: 04 2.7 SWB Terrano II Van Posts: 13,526	Milner Off Road Now people know that I have strong feelings about Milner Off Road now after all of the issues I've had with them in the past. I swore to myself that I would never use them again and have publicly said this on the forum. I was looking for a set of front anti roll bar "D" clamp polybushes last week, I couldn't find a set on eBay they were all rubber ones and the only 1 polybush listing I could find was almost £30 Knowing that Milners used to stock these I headed over to their page and there they were, reluctantly I placed an order. 3 days later this is what turns up in the post I rang them up and went OFF!!!!! The guy on the end of the phone was at least apologetic and did promise that I'd get the correct part a day later which did in fairness turn up. Another quality transaction with our friends in Derby __________________ Moderator 04' Terrano II SE 2.7 TDi SWB Commercial in Silver - Project Thread Toyo Open Country M/T 33's on 10J Steels, Super Strong Steering Job Navara D22 Snorkel, Front LOKKA, Maunal Hubs, EGR Blank TunitII ECU Chip, 3" Body Lift, 2" Suss Lift, Heat Exchanger Black Interior, 3.0 Borg&Beck Clutch, Eckes Heated Fuel Filter 99' Y61 Patrol GR SE 2.8 TD6 LWB in Blue/Silver - Project Thread Engine Transplant - In Progress!!!

25-03-2018, 23:16	#5
macabethiel Senior Member Join Date: Aug 2008 Location: Derby Vehicle: Freelander & Jeep GC 3.0 Posts: 4,416	A run out to Darley Dale for me. I too have had a mixed experience with M.O.R. but they were a cheap source of Polybushes for my old r3mR and very good fully synthetic grade ATF. The best bit was that the Polybushes came with bolts & washers. Not so impressed with the "Boshi"brand of filters. Except for once when they sent me the wrong part I have always driven there even though its a 25 mile each way run.

25-03-2018, 21:06	#2
Jay666d Senior Member Join Date: Jul 2016 Location: Northumberland Vehicle: Patrol GU3 (Y61) 3.0 SVE Posts: 1,375	They must just have your number dude!

25-03-2018, 21:22	#3
jims-terrano Senior Member Join Date: Sep 2004 Location: UK Posts: 12,965	That’s nuts No seriously that is not good at all is it mate but proves exactly what we have said for a while.

25-03-2018, 22:54	#4
terranosaurusdoug Senior Member Join Date: Sep 2014 Location: Yorkshire, J33 M62 Vehicle: 2000 Terrano lwb 2.7TDI Posts: 5,500	I ordered some bits from them once, it was a smooth transaction and quite a pleasurable buying experience overall

26-03-2018, 09:09	#6
RJL Services Senior Member Join Date: Jan 2011 Location: southwest gloucester Vehicle: Nissan Terrano 2.7 2003 Posts: 615	i have never had any problems with them always got want i needed and at a good price when i ordered my brake caliper pins they were actually genuine nissan ones i got too i still continue to use them