I need these

solarman216 · 10-07-2021, 20:29

Hi all can anybody tell me where I can get these for my Y60 Patrol other than OZ thanks Rick

Barrbeast · 10-07-2021, 21:57

What is it Rick? (Don't recognise it as something I've had to replace)

solarman216 · 10-07-2021, 22:41

It bolts onto the front wheel spindle with the disk brake shroud, it helps keep the rubbish from the main hub oil seal, Rick

Barrbeast · 10-07-2021, 22:54

Ah yeh, see it now

https://www.japanese4x4parts.co.uk/n...al-12600-p.asp

solarman216 · 10-07-2021, 23:17

Rob you are an ace I had searched hi and lo for these and drew a blank other than OZ, again thank you so much, best regards Rick

Barrbeast · 11-07-2021, 10:57

Not at all Rick, happy to help!

Flying Torquewrench · 11-07-2021, 13:53

Rob, have you dealt with these guy’s before and had a positive experience?

I have tried to order a few parts from them but even though it says “in stock” on their website I always end up getting a phone call that they can’t source it.

panelbeater · 11-07-2021, 14:11

forum eyes do it again.

solarman216 · 11-07-2021, 20:31

I have tried ordering a couple of those seals but their web site leaves a bit to be desired although I have said that billing and delivery are different when I come to pay they become the same and also have been unable to complete the payment, seems to get stuck in a loop, so will be ringing in the morning, Rick

Banshee · 12-07-2021, 09:00

I've looked into this company before!!! The company address is registered to a very suspicious looking street in Watford!!!

Try calling Rob at the proper Japanese 4x4 Spares, again, his website is not the best but this guy can find ANYTHING, please mention my name when you call (Zac or Banshee)

https://www.japanese4x4spares.co.uk/

Flying Torquewrench · 12-07-2021, 20:54

Rick did you manage to get hold off them?

solarman216 · 12-07-2021, 22:05

Yes hope so as said could not complete on line but rang this morning and two should be coming, about £24 inc post, Nissan wanted £50 each and none in England so a good wait as well, I would have talked about their on line issues but gentleman's English was not too good so gave it a miss, Rick

Flying Torquewrench · 13-07-2021, 10:39

Yes, I noticed as well that his English wasn’t that brilliant. As long as he supplies the goods then that is all that matters.

I was going to say that if he couldn’t supply them you could have added them to my parcel from Oz. Fortunately for you it is not required.

solarman216 · 13-07-2021, 20:29

The shaft seals that I ordered on Saturday came today but completely the wrong ones, after several phone calls the local factors declared that they cannot get axle and gear box seals for my motor, so ordered two from same people I ordered the dust seals with, so stuck it all back together minus the drive shaft and diff oil.

The stub axle oil seal land was in a sorry state so stuck it in the lathe as seen here

solarman216 · 13-07-2021, 20:31

Only took a few thou of it but looking much better and gave it a smooth with 1200 grit emery

10-07-2021, 22:41	#3
solarman216 Off road maniac Join Date: Dec 2009 Location: Bexhill on Sea Vehicle: Y60 Patrol Me, 3 ltr Mrs Posts: 17,427	It bolts onto the front wheel spindle with the disk brake shroud, it helps keep the rubbish from the main hub oil seal, Rick __________________ Ex banger racer now off road maniac Lokka on the front with manual hubs Diff lock on rear 3 inch SS straight through exhaust Manly winch bumper with 13000 lb winch 10 spike ground anchor, with multiple straps and blocks Super strong body cills capped with scaffold pole 20% stronger springs all round aggressive off road tyres on wheels so just swap. Aim to get stuck and be completely self sufficient in extraction, love getting muddy, 2ft deep is good but rare.

10-07-2021, 23:17	#5
solarman216 Off road maniac Join Date: Dec 2009 Location: Bexhill on Sea Vehicle: Y60 Patrol Me, 3 ltr Mrs Posts: 17,427	Rob you are an ace I had searched hi and lo for these and drew a blank other than OZ, again thank you so much, best regards Rick __________________ Ex banger racer now off road maniac Lokka on the front with manual hubs Diff lock on rear 3 inch SS straight through exhaust Manly winch bumper with 13000 lb winch 10 spike ground anchor, with multiple straps and blocks Super strong body cills capped with scaffold pole 20% stronger springs all round aggressive off road tyres on wheels so just swap. Aim to get stuck and be completely self sufficient in extraction, love getting muddy, 2ft deep is good but rare.

11-07-2021, 20:31	#9
solarman216 Off road maniac Join Date: Dec 2009 Location: Bexhill on Sea Vehicle: Y60 Patrol Me, 3 ltr Mrs Posts: 17,427	I have tried ordering a couple of those seals but their web site leaves a bit to be desired although I have said that billing and delivery are different when I come to pay they become the same and also have been unable to complete the payment, seems to get stuck in a loop, so will be ringing in the morning, Rick __________________ Ex banger racer now off road maniac Lokka on the front with manual hubs Diff lock on rear 3 inch SS straight through exhaust Manly winch bumper with 13000 lb winch 10 spike ground anchor, with multiple straps and blocks Super strong body cills capped with scaffold pole 20% stronger springs all round aggressive off road tyres on wheels so just swap. Aim to get stuck and be completely self sufficient in extraction, love getting muddy, 2ft deep is good but rare.

12-07-2021, 09:00	#10
Banshee Moderator Join Date: Jul 2012 Location: West Midlands Vehicle: 04 2.7 SWB Terrano II Van Posts: 13,526	I've looked into this company before!!! The company address is registered to a very suspicious looking street in Watford!!! Try calling Rob at the proper Japanese 4x4 Spares, again, his website is not the best but this guy can find ANYTHING, please mention my name when you call (Zac or Banshee) https://www.japanese4x4spares.co.uk/ __________________ Moderator 04' Terrano II SE 2.7 TDi SWB Commercial in Silver - Project Thread Toyo Open Country M/T 33's on 10J Steels, Super Strong Steering Job Navara D22 Snorkel, Front LOKKA, Maunal Hubs, EGR Blank TunitII ECU Chip, 3" Body Lift, 2" Suss Lift, Heat Exchanger Black Interior, 3.0 Borg&Beck Clutch, Eckes Heated Fuel Filter 99' Y61 Patrol GR SE 2.8 TD6 LWB in Blue/Silver - Project Thread Engine Transplant - In Progress!!!

12-07-2021, 22:05	#12
solarman216 Off road maniac Join Date: Dec 2009 Location: Bexhill on Sea Vehicle: Y60 Patrol Me, 3 ltr Mrs Posts: 17,427	Yes hope so as said could not complete on line but rang this morning and two should be coming, about £24 inc post, Nissan wanted £50 each and none in England so a good wait as well, I would have talked about their on line issues but gentleman's English was not too good so gave it a miss, Rick __________________ Ex banger racer now off road maniac Lokka on the front with manual hubs Diff lock on rear 3 inch SS straight through exhaust Manly winch bumper with 13000 lb winch 10 spike ground anchor, with multiple straps and blocks Super strong body cills capped with scaffold pole 20% stronger springs all round aggressive off road tyres on wheels so just swap. Aim to get stuck and be completely self sufficient in extraction, love getting muddy, 2ft deep is good but rare.

10-07-2021, 21:57	#2
Barrbeast Senior Member Join Date: Mar 2013 Location: Dundee, Scotland Vehicle: 1990 4.2 SWB Safari Posts: 2,615	What is it Rick? (Don't recognise it as something I've had to replace)

10-07-2021, 22:54	#4
Barrbeast Senior Member Join Date: Mar 2013 Location: Dundee, Scotland Vehicle: 1990 4.2 SWB Safari Posts: 2,615	Ah yeh, see it now https://www.japanese4x4parts.co.uk/n...al-12600-p.asp

11-07-2021, 10:57	#6
Barrbeast Senior Member Join Date: Mar 2013 Location: Dundee, Scotland Vehicle: 1990 4.2 SWB Safari Posts: 2,615	Not at all Rick, happy to help!

11-07-2021, 13:53	#7
Flying Torquewrench Senior Member Join Date: May 2011 Location: Worcestershire Vehicle: Nissan Patrol Y61 2.8TD Posts: 1,151	Rob, have you dealt with these guy’s before and had a positive experience? I have tried to order a few parts from them but even though it says “in stock” on their website I always end up getting a phone call that they can’t source it.

11-07-2021, 14:11	#8
panelbeater Senior Member Join Date: Dec 2012 Location: clacton on sea essex Vehicle: nissan terrano 2 2.7 tdi Posts: 1,633	forum eyes do it again.

12-07-2021, 20:54	#11
Flying Torquewrench Senior Member Join Date: May 2011 Location: Worcestershire Vehicle: Nissan Patrol Y61 2.8TD Posts: 1,151	Rick did you manage to get hold off them?

13-07-2021, 10:39	#13
Flying Torquewrench Senior Member Join Date: May 2011 Location: Worcestershire Vehicle: Nissan Patrol Y61 2.8TD Posts: 1,151	Yes, I noticed as well that his English wasn’t that brilliant. As long as he supplies the goods then that is all that matters. I was going to say that if he couldn’t supply them you could have added them to my parcel from Oz. Fortunately for you it is not required.