4 post lift

makeitfit · 01-04-2016, 22:52

Today I are been mainly collecting me 4 post Lift

Poor old Vito had it's work cut out today . It's got lowered suspension and that's why the trailer is low at the front, the hitch is inches off ploughing the tarmac

Plenty of elf n safety tape just to show willing

Not sure how wide one is allowed but 2.95m tends to concentrate the mind a bit

So once re-assembled it should look like this

Black Pearl development will be rad now

Paff · 01-04-2016, 23:13

V Nice

solarman216 · 01-04-2016, 23:28

Very nice, did you lose your rear number plate? Rick

jims-terrano · 01-04-2016, 23:36

You lucky sod

makeitfit · 01-04-2016, 23:39

Quote:

Originally Posted by solarman216

Very nice, did you lose your rear number plate? Rick

stealth mode Rick

makeitfit · 01-04-2016, 23:41

Quote:

Originally Posted by jims-terrano

You lucky sod

Been hunting since November

saintly virtues eventually paid off

RJL Services · 02-04-2016, 00:07

i have a similar ramp as yours mine is a bradbury lift master 2 and has the wheel free system but apart from that is identical good strong ramp

makeitfit · 02-04-2016, 00:10

Quote:

Originally Posted by RJL Services

i have a similar ramp as yours mine is a bradbury lift master 2 and has the wheel free system but apart from that is identical good strong ramp

Will be looking at some kind of wheel free mods soon enough no doubt. Do you know if they did a slide along beam jack thingy for these ?
Just ggoooogggling instructions for it now

Terrano Steve · 02-04-2016, 07:30

I have the slide along beam jack thingy for mine but it needs new seals I will have to get it repaired as they seem to fetch good money at auctions so I wont be replacing it.

RJL Services · 02-04-2016, 09:51

yes they did and most beam jacks are adjustable to fit four post ramps has sliders on jack that you extend to your ramp size then tighten adjuster bolts to secure then it just rolls along the ramp i have a sliding beam jack for mine very useful with the the wheel free i find it great for removing the terrano gearbox as i leave the terrano on the wheel free beams and then slide a couple of planks across and then lower the gearbox out on beam jack and on to the planks then lower the ramp to the floor with no effort at all

Banshee · 02-04-2016, 20:06

And here's me happy with my poxy little garage

I need somewhere big enough for this!!!!

Terrano Steve · 03-04-2016, 07:59

Quote:

Originally Posted by Banshee

And here's me happy with my poxy little garage

I need somewhere big enough for this!!!!

Welcome to use my ramp just drive to cornwall & break something while laning.

01-04-2016, 22:52	#1
makeitfit Senior Member Join Date: Apr 2008 Location: on the beach WEST WALES Vehicle: Maverick TDi BLACK mmm Posts: 15,136	4 post lift Today I are been mainly collecting me 4 post Lift Poor old Vito had it's work cut out today . It's got lowered suspension and that's why the trailer is low at the front, the hitch is inches off ploughing the tarmac Plenty of elf n safety tape just to show willing Not sure how wide one is allowed but 2.95m tends to concentrate the mind a bit So once re-assembled it should look like this Black Pearl development will be rad now

01-04-2016, 23:28	#3
solarman216 Off road maniac Join Date: Dec 2009 Location: Bexhill on Sea Vehicle: Y60 Patrol Me, 3 ltr Mrs Posts: 17,431	Very nice, did you lose your rear number plate? Rick __________________ Ex banger racer now off road maniac Lokka on the front with manual hubs Diff lock on rear 3 inch SS straight through exhaust Manly winch bumper with 13000 lb winch 10 spike ground anchor, with multiple straps and blocks Super strong body cills capped with scaffold pole 20% stronger springs all round aggressive off road tyres on wheels so just swap. Aim to get stuck and be completely self sufficient in extraction, love getting muddy, 2ft deep is good but rare.

02-04-2016, 20:06	#11
Banshee Moderator Join Date: Jul 2012 Location: West Midlands Vehicle: 04 2.7 SWB Terrano II Van Posts: 13,526	And here's me happy with my poxy little garage I need somewhere big enough for this!!!! __________________ Moderator 04' Terrano II SE 2.7 TDi SWB Commercial in Silver - Project Thread Toyo Open Country M/T 33's on 10J Steels, Super Strong Steering Job Navara D22 Snorkel, Front LOKKA, Maunal Hubs, EGR Blank TunitII ECU Chip, 3" Body Lift, 2" Suss Lift, Heat Exchanger Black Interior, 3.0 Borg&Beck Clutch, Eckes Heated Fuel Filter 99' Y61 Patrol GR SE 2.8 TD6 LWB in Blue/Silver - Project Thread Engine Transplant - In Progress!!!

01-04-2016, 23:13	#2
Paff Senior Member Join Date: Apr 2014 Location: Just north of Ipswich, Suffolk Vehicle: Terrano II 2.7 SE+ Auto Posts: 1,094	V Nice

01-04-2016, 23:36	#4
jims-terrano Senior Member Join Date: Sep 2004 Location: UK Posts: 12,965	You lucky sod

02-04-2016, 00:07	#7
RJL Services Senior Member Join Date: Jan 2011 Location: southwest gloucester Vehicle: Nissan Terrano 2.7 2003 Posts: 615	i have a similar ramp as yours mine is a bradbury lift master 2 and has the wheel free system but apart from that is identical good strong ramp

02-04-2016, 07:30	#9
Terrano Steve Senior Member Join Date: Oct 2014 Location: South west Vehicle: Terrano Posts: 522	I have the slide along beam jack thingy for mine but it needs new seals I will have to get it repaired as they seem to fetch good money at auctions so I wont be replacing it.

02-04-2016, 09:51	#10
RJL Services Senior Member Join Date: Jan 2011 Location: southwest gloucester Vehicle: Nissan Terrano 2.7 2003 Posts: 615	yes they did and most beam jacks are adjustable to fit four post ramps has sliders on jack that you extend to your ramp size then tighten adjuster bolts to secure then it just rolls along the ramp i have a sliding beam jack for mine very useful with the the wheel free i find it great for removing the terrano gearbox as i leave the terrano on the wheel free beams and then slide a couple of planks across and then lower the gearbox out on beam jack and on to the planks then lower the ramp to the floor with no effort at all