21-05-2014, 20:52 | #1 |
Senior Member
Join Date: Jan 2014
Location: Uk
Vehicle: 2004 Terrano 2.7 TDI
Posts: 7,847
|
New rear bumper
Hi all, so today i paid the almighty Rick a visit with the hope of re indexing the front torsion bar, after some debate we decided against the front torsion indexing due to stress.
So with the leak off pipes easily tackled we started chatting about mods on here, I mentioned makeitfit's steel bumper, at which point rick mentioned he had a special set of bumpers in led of a lick of paint. Needless to say I snatched them up The rear one has been fitted to get me home and I'm returning to get the front one done later As usual rick, you are a legend |
21-05-2014, 22:39 | #2 | |
Moderator
Join Date: Jul 2012
Location: West Midlands
Vehicle: 04 2.7 SWB Terrano II Van
Posts: 13,526
|
Quote:
Not my cup of tea but gives you some nice clearance for off roading I suppose
__________________
Moderator 04' Terrano II SE 2.7 TDi SWB Commercial in Silver - Project Thread Toyo Open Country M/T 33's on 10J Steels, Super Strong Steering Job Navara D22 Snorkel, Front LOKKA, Maunal Hubs, EGR Blank TunitII ECU Chip, 3" Body Lift, 2" Suss Lift, Heat Exchanger Black Interior, 3.0 Borg&Beck Clutch, Eckes Heated Fuel Filter 99' Y61 Patrol GR SE 2.8 TD6 LWB in Blue/Silver - Project Thread Engine Transplant - In Progress!!! |
|
21-05-2014, 23:21 | #3 | |
Senior Member
Join Date: Jan 2014
Location: Uk
Vehicle: 2004 Terrano 2.7 TDI
Posts: 7,847
|
Quote:
I also need a rubber grommet for the drivers side rear, any ideas where? |
|
21-05-2014, 23:21 | #4 |
Senior Member
Join Date: May 2013
Location: Northumberland
Vehicle: Terrano 2.7TDI SE LWB
Posts: 3,604
|
It looks nice & strong the styling of it isn't for me but hay it's your motor not mine
|
21-05-2014, 23:24 | #5 |
Senior Member
Join Date: Jan 2014
Location: Uk
Vehicle: 2004 Terrano 2.7 TDI
Posts: 7,847
|
|
21-05-2014, 23:32 | #6 |
Senior Member
Join Date: Sep 2004
Location: UK
Posts: 12,965
|
Just to be on the safe side you might be better taking it to show an mot station and asking if they'll pass. Those rear wheel s look a little exposed to me.
|
21-05-2014, 23:40 | #7 |
Senior Member
Join Date: Mar 2013
Location: Dundee, Scotland
Vehicle: 1990 4.2 SWB Safari
Posts: 2,615
|
Think he'll be ok Jim, if you check Adz's pic thread he took his rear bumper off completely. Think the only thing they're bothered about is sharp edges that folk could cut/stab themselves on (we'll ignore the question of why they'd be that close to the rear of the truck in the first place)
Looking good Alex, remember you'll need a winch in your front bumper to make it road legal |
21-05-2014, 23:44 | #8 |
Senior Member
Join Date: Sep 2004
Location: UK
Posts: 12,965
|
That's good then, it would be bad news to of binned your old bumpers and then fail mot. Enjoy your modding Alex.
|
21-05-2014, 23:47 | #9 |
Senior Member
Join Date: May 2013
Location: Northumberland
Vehicle: Terrano 2.7TDI SE LWB
Posts: 3,604
|
You'll have to get the rear number plate remounted now you should be fine with the MOT & boys in blue as the tyres are covered at the top by the arches
|
21-05-2014, 23:50 | #10 | |
Off road maniac
Join Date: Dec 2009
Location: Bexhill on Sea
Vehicle: Y60 Patrol Me, 3 ltr Mrs
Posts: 17,429
|
Quote:
__________________
Ex banger racer now off road maniac Lokka on the front with manual hubs Diff lock on rear 3 inch SS straight through exhaust Manly winch bumper with 13000 lb winch 10 spike ground anchor, with multiple straps and blocks Super strong body cills capped with scaffold pole 20% stronger springs all round aggressive off road tyres on wheels so just swap. Aim to get stuck and be completely self sufficient in extraction, love getting muddy, 2ft deep is good but rare. |
|
21-05-2014, 23:57 | #11 |
Senior Member
Join Date: Mar 2013
Location: Dundee, Scotland
Vehicle: 1990 4.2 SWB Safari
Posts: 2,615
|
Under EU regs a steel front bumper is frontal protection and therefore not road legal but fit a winch and it becomes a winch bumper which counts as equipment and is road legal.
I'm saying nothing! |
22-05-2014, 00:05 | #12 |
Off road maniac
Join Date: Dec 2009
Location: Bexhill on Sea
Vehicle: Y60 Patrol Me, 3 ltr Mrs
Posts: 17,429
|
Yea OK
__________________
Ex banger racer now off road maniac Lokka on the front with manual hubs Diff lock on rear 3 inch SS straight through exhaust Manly winch bumper with 13000 lb winch 10 spike ground anchor, with multiple straps and blocks Super strong body cills capped with scaffold pole 20% stronger springs all round aggressive off road tyres on wheels so just swap. Aim to get stuck and be completely self sufficient in extraction, love getting muddy, 2ft deep is good but rare. |
22-05-2014, 08:59 | #13 | |
Senior Member
Join Date: Jan 2014
Location: Uk
Vehicle: 2004 Terrano 2.7 TDI
Posts: 7,847
|
Quote:
Or literally tie the Tirfor to my new front bumper to be |
|
22-05-2014, 09:05 | #14 |
Senior Member
Join Date: Jan 2014
Location: Uk
Vehicle: 2004 Terrano 2.7 TDI
Posts: 7,847
|
I've just had a "great" though
Im gonna get the exact definition of "winch" and see what I can get away with. Example - if I could just have 1m of cable with a hook sitting on the ring id be laughing. Don't really wanna buy a 300 quid elec winch. |
22-05-2014, 09:22 | #15 |
Senior Member
Join Date: Dec 2012
Location: west midlands
Vehicle: terrano se 2.7
Posts: 1,041
|
Pop some extra rear lighting in those circular holes will help the look of it mate.
|
|
|