Scrapping T2 - Page 2

solarman216 · 28-10-2014, 10:51

Quote:

Originally Posted by t2chris

Got any crank position sensors that go into the front of the chest mate?

Intercooler football is the new craze clive lol, but hope royal mail give you money back mate!

Got several sensors but I will have to check if I have a front one, cannot remember if they are the same, Rick

rusty nuts · 28-10-2014, 11:28

Have you got a heater resistor?

Smiler AS · 28-10-2014, 17:54

Any of them commercials?

R1cho · 28-10-2014, 18:34

i'm after the boot light unit that goes in the rear where the tailgate door is if you have one

clivvy · 28-10-2014, 19:18

i don't suppose you have one in my colour, do you?

solarman216 · 28-10-2014, 19:51

Quote:

Originally Posted by t2chris

Got any crank position sensors that go into the front of the chest mate?

Had a look but only got Bosch ones that go in the bell housing, I have two running motors with the Zexel pump with CPS in timing case and they are both different on has one bolt the other has two, they should read 1500 ohms resistance, the Bosch ones read less than 1000, Rick

t2chris · 28-10-2014, 19:57

Quote:

Originally Posted by solarman216

Had a look but only got Bosch ones that go in the bell housing, I have two running motors with the Zexel pump with CPS in timing case and they are both different on has one bolt the other has two, they should read 1500 ohms resistance, the Bosch ones read less than 1000, Rick

Thanks for looking Rick, mine has the one bolt and three pin connector, I imagine since i have hitachi maf then I dont have bosch cps?!

What would you want for that one mate?

Chris

solarman216 · 28-10-2014, 20:01

Rusty nuts,,, what Mk I have one for the Mk 1 not for Mk2

Smiler,,, no commercials.

R1cho,,,,no boot light used the last one on Mrs motor as it fell to bits changing the bulb

Clivvy ,,, nearest I have is an early Mk 1 looks similar in colour, it is the LPG one that I would like to sell as seems a shame to break it with MOT till July next year, Rick

solarman216 · 28-10-2014, 20:05

Quote:

Originally Posted by t2chris

Thanks for looking Rick, mine has the one bolt and three pin connector, I imagine since i have hitachi maf then I dont have bosch cps?!

What would you want for that one mate?

Chris

The Bosch one is no good to you as although it has one bolt and may fit the hole (I do not know) the coil resistance is around 800 ohms, far too low against your 1500, Rick

R1cho · 28-10-2014, 22:14

Quote:

Originally Posted by solarman216

R1cho,,,,no boot light used the last one on Mrs motor as it fell to bits changing the bulb

thats what happened to mine

melissachels · 03-11-2014, 13:18

Is it td's or Tdi's you scraping Rick?

Phil's got some tdi wiring for me, but struggling to get wireing looms for td. Would be looking for the wiring loom that attachs to the ecu & the fuel pump ones.

Cheers,
Mel

Mark charlesworth · 03-11-2014, 17:53

Bosch maf sensor if you got one, and an auto gearbox please

panelbeater · 03-11-2014, 18:39

any matching 15" t2 alloys

solarman216 · 03-11-2014, 19:12

Quote:

Originally Posted by melissachels

Is it td's or Tdi's you scraping Rick?

Phil's got some tdi wiring for me, but struggling to get wireing looms for td. Would be looking for the wiring loom that attachs to the ecu & the fuel pump ones.

Cheers,
Mel

The Diesel one is a TDi if you want the loom it is still all there, Rick

solarman216 · 03-11-2014, 19:13

Quote:

Originally Posted by Mark charlesworth

Bosch maf sensor if you got one, and an auto gearbox please

Bosch Maf has gone, and only manual boxes sorry, Rick

28-10-2014, 20:01	#23
solarman216 Off road maniac Join Date: Dec 2009 Location: Bexhill on Sea Vehicle: Y60 Patrol Me, 3 ltr Mrs Posts: 17,432	Rusty nuts,,, what Mk I have one for the Mk 1 not for Mk2 Smiler,,, no commercials. R1cho,,,,no boot light used the last one on Mrs motor as it fell to bits changing the bulb Clivvy ,,, nearest I have is an early Mk 1 looks similar in colour, it is the LPG one that I would like to sell as seems a shame to break it with MOT till July next year, Rick __________________ Ex banger racer now off road maniac Lokka on the front with manual hubs Diff lock on rear 3 inch SS straight through exhaust Manly winch bumper with 13000 lb winch 10 spike ground anchor, with multiple straps and blocks Super strong body cills capped with scaffold pole 20% stronger springs all round aggressive off road tyres on wheels so just swap. Aim to get stuck and be completely self sufficient in extraction, love getting muddy, 2ft deep is good but rare.

28-10-2014, 11:28	#17
rusty nuts Senior Member Join Date: Oct 2014 Location: bristol Vehicle: T2 2.7 tdi Posts: 101	Have you got a heater resistor?

28-10-2014, 17:54	#18
Smiler AS Senior Member Join Date: Feb 2014 Location: N.East Scotland Vehicle: 06 Terrano 3.0 SVE SWB Posts: 125	Any of them commercials?

28-10-2014, 18:34	#19
R1cho Senior Member Join Date: Aug 2010 Location: Wales Vehicle: 1997 LandCruiser Colorado Posts: 4,201	i'm after the boot light unit that goes in the rear where the tailgate door is if you have one

28-10-2014, 19:18	#20
clivvy Senior Member Join Date: Mar 2009 Location: Huddersfield Vehicle: Terrano 03 LWB Posts: 6,947	i don't suppose you have one in my colour, do you?

03-11-2014, 13:18	#26
melissachels Senior Member Join Date: Mar 2012 Location: Near Armagh, Northern Ireland Vehicle: half of a T2 2.7td swb Posts: 1,216	Is it td's or Tdi's you scraping Rick? Phil's got some tdi wiring for me, but struggling to get wireing looms for td. Would be looking for the wiring loom that attachs to the ecu & the fuel pump ones. Cheers, Mel

03-11-2014, 17:53	#27
Mark charlesworth Senior Member Join Date: Jun 2014 Location: England Vehicle: Nissan terrano Posts: 124	Bosch maf sensor if you got one, and an auto gearbox please

03-11-2014, 18:39	#28
panelbeater Senior Member Join Date: Dec 2012 Location: clacton on sea essex Vehicle: nissan terrano 2 2.7 tdi Posts: 1,639	any matching 15" t2 alloys