Paper clip

[Mark charlesworth]

Thanks for the info Rick will look tomorrow

[spautoparts]

I have the exact same problem with mine. Mine also is the automatic gearbox. When I put it into gear it sometimes stalls the engine and I get code 18. I switch off the engine and back on and it clears it. Ive been putting up with it for almost a year but really want to get it sorted.

[davenclaire]

im happy to plug you into my laptop to check and clear your codes.
iv also resealed our injector pump while still on the car so iv become dare i say it bit of an expert on the ip. happy to help out where abouts are you?

[Mark charlesworth]

I'm in Eltham just off the a2

[davenclaire]

well blow me down im in orpington next door. for what its worth i think your control sleeve position sensor housing needs a little adjustement you cant turn the tick over up but slight adjustments to the housing have the same effect. you may also have a leaking pump usually the seals go hard n brittle look up my post on resealing the pump it shows you where to look

[Mark charlesworth]

Small world will look it up now I just ordered an ecutalk of eBay not that I would know how to use it, trying to get the eml sorted as I have my final assessment in a couple of weeks with south east 4x4 response

[davenclaire]

Originally Posted by Mark charlesworth

Small world will look it up now I just ordered an ecutalk of eBay not that I would know how to use it, trying to get the eml sorted as I have my final assessment in a couple of weeks with south east 4x4 response

takes 5 mins to plug in and read ur codes n reset eml

[Mark charlesworth]

When would it be convenient to pop over