Joined for a friend with Terrano problems. - Page 2

barney russel · 28-08-2018, 23:32

I'll tell him to check it, not sure of its quality though, apparently there were fault codes although i don't know what they were, do these pumps usually cause problems? the mechanic rang Nissan and whatever the issue is they said there is such a part,

Thanks for the welcome

jims-terrano · 29-08-2018, 07:14

Just a thought, in quick links we have a download section. There used to be a manual for the Terrano but I’m not sure it is still available.

barney russel · 29-08-2018, 08:13

That could be handy,

Thanks Jim.

Banshee · 29-08-2018, 08:48

You can read the codes yourself at home with nothing more than a paperclip, some simple adding up and a cup of tea (optional)

There will be a 16 pin plug underneath the fusebox located underneath the steering wheel near the drivers right leg. If you bridge the first pin on the bottom row with the last pin on the bottom row and switch the ignition on you'll see that the MIL light or (malfunction indication light) will start blinking at you.

You will see a series of long flashes and short flashes, a long flash is 10 and a short flash is 1, so for example when I had a problem with my Injection pump on my 2.7 I kept getting code 21 which was 2 long flashes and 1 short, the truck will cycle through the codes until you remove the paperclip.

You can check what the codes relate to here;
http://www.nissan4x4ownersclub.com/d...kshop/wk29.pdf

This will give you as much info as your local garages fancy £500 Snap On reader

Guys, who was it that was sorting the workshop manuals page out as I still can't gt to them?

barney russel · 29-08-2018, 09:10

Similar to the older Astras then, thanks for the info, that could come in handy.

Leelad · 26-11-2018, 18:12

Hi does anyone know if I can get rid of the immobiliser on my terranno 2 ? Without having to pay garage a fortune ‘n

solarman216 · 26-11-2018, 19:01

Quote:

Originally Posted by Leelad

Hi does anyone know if I can get rid of the immobiliser on my terranno 2 ? Without having to pay garage a fortune ‘n

Only way I know is to change to a mechanical pump, Rick

jims-terrano · 26-11-2018, 19:25

Quote:

Originally Posted by Leelad

Hi does anyone know if I can get rid of the immobiliser on my terranno 2 ? Without having to pay garage a fortune ‘n

What’s actually happening that makes you want to disconnect the immobiliser?

29-08-2018, 08:48	#19
Banshee Moderator Join Date: Jul 2012 Location: West Midlands Vehicle: 04 2.7 SWB Terrano II Van Posts: 13,526	You can read the codes yourself at home with nothing more than a paperclip, some simple adding up and a cup of tea (optional) There will be a 16 pin plug underneath the fusebox located underneath the steering wheel near the drivers right leg. If you bridge the first pin on the bottom row with the last pin on the bottom row and switch the ignition on you'll see that the MIL light or (malfunction indication light) will start blinking at you. You will see a series of long flashes and short flashes, a long flash is 10 and a short flash is 1, so for example when I had a problem with my Injection pump on my 2.7 I kept getting code 21 which was 2 long flashes and 1 short, the truck will cycle through the codes until you remove the paperclip. You can check what the codes relate to here; http://www.nissan4x4ownersclub.com/d...kshop/wk29.pdf This will give you as much info as your local garages fancy £500 Snap On reader Guys, who was it that was sorting the workshop manuals page out as I still can't gt to them? __________________ Moderator 04' Terrano II SE 2.7 TDi SWB Commercial in Silver - Project Thread Toyo Open Country M/T 33's on 10J Steels, Super Strong Steering Job Navara D22 Snorkel, Front LOKKA, Maunal Hubs, EGR Blank TunitII ECU Chip, 3" Body Lift, 2" Suss Lift, Heat Exchanger Black Interior, 3.0 Borg&Beck Clutch, Eckes Heated Fuel Filter 99' Y61 Patrol GR SE 2.8 TD6 LWB in Blue/Silver - Project Thread Engine Transplant - In Progress!!!

28-08-2018, 23:32	#16
barney russel Member Join Date: Aug 2018 Location: Hampshire Vehicle: astra Posts: 68	I'll tell him to check it, not sure of its quality though, apparently there were fault codes although i don't know what they were, do these pumps usually cause problems? the mechanic rang Nissan and whatever the issue is they said there is such a part, Thanks for the welcome

29-08-2018, 07:14	#17
jims-terrano Senior Member Join Date: Sep 2004 Location: UK Posts: 12,965	Just a thought, in quick links we have a download section. There used to be a manual for the Terrano but I’m not sure it is still available.

29-08-2018, 08:13	#18
barney russel Member Join Date: Aug 2018 Location: Hampshire Vehicle: astra Posts: 68	That could be handy, Thanks Jim.

29-08-2018, 09:10	#20
barney russel Member Join Date: Aug 2018 Location: Hampshire Vehicle: astra Posts: 68	Similar to the older Astras then, thanks for the info, that could come in handy.

26-11-2018, 18:12	#21
Leelad Junior Member Join Date: Nov 2018 Location: Somerset Vehicle: Nissan Terrano 2 Posts: 1	Hi does anyone know if I can get rid of the immobiliser on my terranno 2 ? Without having to pay garage a fortune ‘n