Latest project started Monday to keep me busy - Page 11

solarman216 · 12-10-2017, 20:43

Close up

solarman216 · 12-10-2017, 20:45

Floor tiles

solarman216 · 12-10-2017, 20:51

Disabled WC part tilled

solarman216 · 12-10-2017, 20:53

Ladies WC being tilled, all for now Rick

solarman216 · 12-10-2017, 20:58

Quote:

Originally Posted by rayf3262

This is the type of differential pressure switch we use at the University on extract and AHU's. One 6mm tube either side of of the fan.
http://uk.rs-online.com/web/p/produc...xoCL0UQAvD_BwE

The controller I have been supplied with is simply a diff pressure sensor that detects lower pressure in the canopy side of the fan together with a current draw to the fan, yet to get a gas control valve till I know what size pipe I will be using, Rick

terranosaurusdoug · 12-10-2017, 21:54

Quote:

Originally Posted by solarman216

Bought a 50 Mtr roll off pipe earlier in the week, unwrapped it today with the intention of running it through a narrow ceiling void, only to find it is 15 mm not 22, so that job was abandoned

Yeah blue for 15 and purple-ish for 22.

solarman216 · 12-10-2017, 22:59

Quote:

Originally Posted by terranosaurusdoug

Yeah blue for 15 and purple-ish for 22.

Thanks mate, do not buy enough to know that, but good that my pic shows that so can argue tomorrow against an invoice for 22mm, Rick

terranosaurusdoug · 13-10-2017, 01:01

Quote:

Originally Posted by solarman216

Thanks mate, do not buy enough to know that, but good that my pic shows that so can argue tomorrow against an invoice for 22mm, Rick

Should be unmistakable to anyone who works in a merchants

solarman216 · 13-10-2017, 01:27

Quote:

Originally Posted by terranosaurusdoug

Should be unmistakable to anyone who works in a merchants

My local I am afraid are not the best but I get good terms so put up with it, I still have a 10k limit although mostly I only spend a couple of hundred, Rick

solarman216 · 13-10-2017, 20:43

The only bit of CH pipe seen on supply run to raised deck area apart from feeds to rads

solarman216 · 13-10-2017, 20:44

Rear shelving of bar etc

solarman216 · 13-10-2017, 20:55

Next WC stripped and to be tilled

solarman216 · 13-10-2017, 21:00

Corridor to wash area started white board so lecy could mount light switch

solarman216 · 13-10-2017, 21:13

From wash area to kitchen, getting a bit tight for space now, lots done this week but not too much for good pics, 3 weeks left, just done a recy on what is left to do! lecy can cope, Dave and his lads as well (lots to do but there are 4 of them) Data/security guy has it easy, I can cope with gas, domestic plumbing, air con for beer cellar, ducting for canopy and full heating plus sorting other trades problems, the grey area is the tilers, at their current rate of progress they stand no chance, in total we have over 5 tonnes of ceramic tiles to lay/apply so far they have not even completed one WC, words next week,

, all this week Rick

solarman216 · 16-10-2017, 20:14

No pics today, just too much going on, just seen the WC basins and taps etc, cannot wait to be fitting those, started running gas pipe 42 mm from meter to ceiling void where it will be accessible, then drop down to 35 mm, if they add further gas appliances later then it will be easy to upgrade to 42 all the way but at this time have to look at cost, 42 pipe is not cheap, I was asked today about 1.5 inch black iron barrel, problem is it comes red oxide painted, no good at all, owner has found it on the net, need 100 x .900 mm pieces & 200 floor plates

this is for the balustrade around the raised seating area, tillers recon they have up to ten guys available, with less than 3 weeks left they may need them, hope to have some progress pics tomorrow, Rick

16-10-2017, 20:14	#165
solarman216 Off road maniac Join Date: Dec 2009 Location: Bexhill on Sea Vehicle: Y60 Patrol Me, 3 ltr Mrs Posts: 17,431	No pics today, just too much going on, just seen the WC basins and taps etc, cannot wait to be fitting those, started running gas pipe 42 mm from meter to ceiling void where it will be accessible, then drop down to 35 mm, if they add further gas appliances later then it will be easy to upgrade to 42 all the way but at this time have to look at cost, 42 pipe is not cheap, I was asked today about 1.5 inch black iron barrel, problem is it comes red oxide painted, no good at all, owner has found it on the net, need 100 x .900 mm pieces & 200 floor plates this is for the balustrade around the raised seating area, tillers recon they have up to ten guys available, with less than 3 weeks left they may need them, hope to have some progress pics tomorrow, Rick __________________ Ex banger racer now off road maniac Lokka on the front with manual hubs Diff lock on rear 3 inch SS straight through exhaust Manly winch bumper with 13000 lb winch 10 spike ground anchor, with multiple straps and blocks Super strong body cills capped with scaffold pole 20% stronger springs all round aggressive off road tyres on wheels so just swap. Aim to get stuck and be completely self sufficient in extraction, love getting muddy, 2ft deep is good but rare.