|
|
|
|||||||
| Caravan or Towing In this forum you can post anything with regards to caravaning or towing. |
 |
|
|
Thread Tools | Display Modes |
16-09-2018, 22:03
|
#1 |
|
Junior Member
 Join Date: Sep 2018
Location: New Forest
Vehicle: Nissan xtrail artix 2008
Posts: 16
|
Advice re towbar fitting
Hi I am a newbie so please bear with me I have a Nissan xtrail artix 2008 diesel auto I want to fit a witter towbar e11-00-6957 that I’m getting of a selling site I’ve checked with witter site and it’s a fit for my exxy but wondered if you guys can advise how it’s fitted to the back of car If you got a copy of fitting instructions I’d appreciate a copy or just a guide from yourselves of how it’s done Thanks in advance
|
|
|
|
16-09-2018, 23:12
|
#2 |
|
Off road maniac
 
Join Date: Dec 2009
Location: Bexhill on Sea
Vehicle: Y60 Patrol Me, 3 ltr Mrs
Posts: 17,430
|
Welcome mate, sorry but I know nothing about Xtrails, Rick
__________________
Ex banger racer now off road maniac  Lokka on the front with manual hubs Diff lock on rear 3 inch SS straight through exhaust Manly winch bumper with 13000 lb winch 10 spike ground anchor, with multiple straps and blocks Super strong body cills capped with scaffold pole 20% stronger springs all round aggressive off road tyres on wheels so just swap. Aim to get stuck and be completely self sufficient in extraction, love getting muddy, 2ft deep is good but rare. |
|
|
|
16-09-2018, 23:19
|
#3 |
|
Senior Member
Join Date: Sep 2004
Location: UK
Posts: 12,965
|
Welcome aboard. Sorry same as above. You could try youtube as I’ve found towbar instructions on their.
|
|
|
|
|
16-09-2018, 23:36
|
#4 |
|
Senior Member
Join Date: Sep 2004
Location: UK
Posts: 12,965
|
|
|
|
|
|
17-09-2018, 11:21
|
#5 |
|
Junior Member
Join Date: Sep 2018
Location: New Forest
Vehicle: Nissan xtrail artix 2008
Posts: 16
|
Thanks
Thanks guy but I’ve googled and I tuned but no exxy every other Nissan but no exxy other than t30 mines t31 and think there’s a difference But thanks for the advice I’ll keep hoping lol
|
|
|
|
|
17-09-2018, 21:36
|
#6 |
|
Moderator
 
Join Date: Jul 2012
Location: West Midlands
Vehicle: 04 2.7 SWB Terrano II Van
Posts: 13,526
|
Fairly straight forward mate
If it's anything like the Terrano it will just entail entering the rear of the truck tub via a grommet and then tapping into the existing rear wiring loom and running the cable down behind the rear bumper and across onto the towbar and then into your 7 PIN plug Towbar should just be a case of bolting on. I'm sure there will be a wiring diagram somewhere if you get to that stage
__________________
Moderator 04' Terrano II SE 2.7 TDi SWB Commercial in Silver - Project Thread Toyo Open Country M/T 33's on 10J Steels, Super Strong Steering Job Navara D22 Snorkel, Front LOKKA, Maunal Hubs, EGR Blank TunitII ECU Chip, 3" Body Lift, 2" Suss Lift, Heat Exchanger Black Interior, 3.0 Borg&Beck Clutch, Eckes Heated Fuel Filter 99' Y61 Patrol GR SE 2.8 TD6 LWB in Blue/Silver - Project Thread Engine Transplant - In Progress!!! |
|
|
|
|
|
|
Linear Mode
