Go Back   :::.Nissan 4x4 Owners Club.::: > General > The Clubs Virtual Pub

The Clubs Virtual Pub For general chat, so come on in and pull up a chair.

Reply
 
Thread Tools Display Modes
Old 12-09-2014, 13:45   #1
Terranical
Senior Member
Click here to find out how to become a paid up member
 
Join Date: Jun 2010
Location: Resident in Bristol, Terrano in Spain
Vehicle: 1994 Terrano 2.7TD SWB
Posts: 1,398
Default New cv joint rubber boot

Just had a new n/s boot fitted on the drive shaft here in Spain (proper job, not the "zip" type) - €48! That's around £42. Hour and a half labour at €24 an hour and €12 for the boot, that seems remarkably cheap to me. Anyone have any idea how much that would cost in the UK?
Terranical is offline   Reply With Quote
Old 12-09-2014, 14:02   #2
AlexD333
Senior Member
Click here to find out how to become a paid up member
 
Join Date: Jan 2014
Location: Uk
Vehicle: 2004 Terrano 2.7 TDI
Posts: 7,847
Default

Quote:
Originally Posted by Terranical View Post
Just had a new n/s boot fitted on the drive shaft here in Spain (proper job, not the "zip" type) - €48! That's around £42. Hour and a half labour at €24 an hour and €12 for the boot, that seems remarkably cheap to me. Anyone have any idea how much that would cost in the UK?
Don't forget you are in terrano country

And th answer to your question would be "more"
AlexD333 is offline   Reply With Quote
Old 12-09-2014, 16:30   #3
Banshee
Moderator
 
Banshee's Avatar
 
Join Date: Jul 2012
Location: West Midlands
Vehicle: 04 2.7 SWB Terrano II Van
Posts: 13,526
Default

Quote:
Originally Posted by AlexD333 View Post
Don't forget you are in terrano country

And the answer to your question would be "more"
Not if you do it yourself, super easy job, in fact I have one to do on the new motor, thankfully it's an outer one, I've been told that the inner ones are a ballache as you have to unbolt the driveshaft on the transfer box and lose alll the fluid on the floor lol

I've used the split type ones and they are terrible. I've recently purchased a Bailcast fitting cone that makes installing them a breeze
__________________
Moderator

04' Terrano II SE 2.7 TDi SWB Commercial in Silver - Project Thread
Toyo Open Country M/T 33's on 10J Steels, Super Strong Steering Job
Navara D22 Snorkel, Front LOKKA, Maunal Hubs, EGR Blank
TunitII ECU Chip, 3" Body Lift, 2" Suss Lift, Heat Exchanger
Black Interior, 3.0 Borg&Beck Clutch, Eckes Heated Fuel Filter


99' Y61 Patrol GR SE 2.8 TD6 LWB in Blue/Silver - Project Thread
Engine Transplant - In Progress!!!
Banshee is offline   Reply With Quote
Old 12-09-2014, 18:43   #4
RJL Services
Senior Member
Click here to find out how to become a paid up member
 
Join Date: Jan 2011
Location: southwest gloucester
Vehicle: Nissan Terrano 2.7 2003
Posts: 615
Default

i Changed one last week and unbolted the shaft of the transfer box and no fluid came out as it bolted to flange this was on a 1999 model
RJL Services is offline   Reply With Quote
Old 12-09-2014, 19:37   #5
bry
Senior Member
Click here to find out how to become a paid up member
 
Join Date: May 2013
Location: South Yorkshire..
Vehicle: Nissan Terrano MK 2 SE
Posts: 1,757
Default

I replaced both cv joints, never lost any oil.
bry is offline   Reply With Quote
Old 12-09-2014, 21:38   #6
solarman216
Off road maniac
Click here to find out how to become a paid up member
 
solarman216's Avatar
 
Join Date: Dec 2009
Location: Bexhill on Sea
Vehicle: Y60 Patrol Me, 3 ltr Mrs
Posts: 17,430
Default

Erm????? they do not fit to the transfer box but to the front diff, no oil can be lost from this as the flanges that the shafts fit too are part of the front diff, think someone may be mistaking this for another vehicle, Rick
__________________
Ex banger racer now off road maniac
Lokka on the front with manual hubs
Diff lock on rear
3 inch SS straight through exhaust
Manly winch bumper with 13000 lb winch
10 spike ground anchor, with multiple straps and blocks
Super strong body cills capped with scaffold pole
20% stronger springs all round
aggressive off road tyres on wheels so just swap.
Aim to get stuck and be completely self sufficient in extraction, love getting muddy, 2ft deep is good but rare.
solarman216 is offline   Reply With Quote
Old 12-09-2014, 22:00   #7
Banshee
Moderator
 
Banshee's Avatar
 
Join Date: Jul 2012
Location: West Midlands
Vehicle: 04 2.7 SWB Terrano II Van
Posts: 13,526
Default

Oops I think I've made a boo boo I meant diff lol
__________________
Moderator

04' Terrano II SE 2.7 TDi SWB Commercial in Silver - Project Thread
Toyo Open Country M/T 33's on 10J Steels, Super Strong Steering Job
Navara D22 Snorkel, Front LOKKA, Maunal Hubs, EGR Blank
TunitII ECU Chip, 3" Body Lift, 2" Suss Lift, Heat Exchanger
Black Interior, 3.0 Borg&Beck Clutch, Eckes Heated Fuel Filter


99' Y61 Patrol GR SE 2.8 TD6 LWB in Blue/Silver - Project Thread
Engine Transplant - In Progress!!!
Banshee is offline   Reply With Quote
Old 13-09-2014, 09:37   #8
firebobby
Senior Member
Click here to find out how to become a paid up member
 
Join Date: Feb 2012
Location: South Bucks
Vehicle: Terrano 3.0 SVE 2005
Posts: 3,499
Default

Quote:
Originally Posted by Banshee View Post
Oops I think I've made a boo boo I meant diff lol
Oh Banshee, what are you like

Is there a down section on this ( to lazy to look ) if not, a photo write up may help others if your doing yours
firebobby is offline   Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


All times are GMT +1. The time now is 07:57.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Images online photo albums