Piccadilly wood this Sunday

solarman216 · 03-12-2021, 19:59

As title I am off to the wood this Sunday before the prats that run this country shut it down again, we are booked into two good eateries Xmas day and Boxing day, however if they shut them down we will be having the whole family round for Xmas festivities instead, the world has gone stark raving mad, have a good one Rick

solarman216 · 04-12-2021, 23:24

All set for tomorrow, but had one big issue, when I fitted the off road wheels one of the fronts was flat, some months since I last used them and the problem is they are fitted with tubes and the valve had vanished, had a hunt round for an alternative as the tyre place could not promise to have it done by 5 when they close, found one but it is a Terrano wheel and they need a small mod to fit which we did with Mr angle grinder, then realised that the tyre for the NSF was on the wrong way round, ah well it roles so good enough, then the tyre place rang to say my one was all good, so stuck that in the back as spare, not changing it now, hope to have some nice pics tomorrow, Rick

makeitfit · 04-12-2021, 23:32

I get days like that ��
We were ďoing the clutch the other day. All going well you'll I pulled the gearbox back. It felt a little "springy" so the boy gave ne a hand and ping, off it came. The springy was the bloody crank sensor onto of the box �� Wasn't one on the Black Pearl ��
Couldn't start the engine, not even any limp mode action ��
Found one 30 miles away . Went to get it only gor the bloke selling to snap the bugger taking it out ��
Had to buy a new one . So one clutch ,3 days ��

solarman216 · 05-12-2021, 00:57

Yep that's life Pete, that will be a Bosch one, the Zexel is on the timing cover, Rick

solarman216 · 05-12-2021, 23:03

Had a grand day at the wood today, no real heavy rain for a long time so the site was mainly a thin coating of mud on hard soil under which made things interesting, ie no grip at all in the drier places, very little in the way of still pics but what I do have will follow, do have full vid of whole day but will take time to go through it all.

what we see in the 5 pics to follow are just one area that proved problematic.

Above us to the right is a stuck motor with a burnt out clutch, we were coming down from high up on the left but due to the stuck motor we could not proceed, there was a track to our right that I though came out at a lower level but impossible to climb up from previous knowledge but going down will be good, wrong it simply took us down into a real boggy U that came up to the same track that the burnt clutch was on, saw the site owner with his tractor recovering the clutch job and he said will not even take his tractor down there, so here we are after negotiating the deep mud and unable to go back

solarman216 · 05-12-2021, 23:05

Another angle

solarman216 · 05-12-2021, 23:07

End of single line pull as winch straining, it is steeper than it looks

solarman216 · 05-12-2021, 23:14

Hard pull with block and line back to truck, 2nd row on drum so around 20,000Lb pull

solarman216 · 05-12-2021, 23:19

Nearly out, that is all folks till I get some video sorted, but we had many more winch trials like that today, not just us but helping others out, Rick

panelbeater · 07-12-2021, 16:15

nice picks rick,did anyone watch Guy in the program to change a fkd disco to a racing one on 5 i think.put a brand new chassis and home built roll cage,good welding and the tracks they raced on and it coped was very amusing tot watch.
i do like watching him in his antics.

03-12-2021, 19:59	#1
solarman216 Off road maniac Join Date: Dec 2009 Location: Bexhill on Sea Vehicle: Y60 Patrol Me, 3 ltr Mrs Posts: 17,431	Piccadilly wood this Sunday As title I am off to the wood this Sunday before the prats that run this country shut it down again, we are booked into two good eateries Xmas day and Boxing day, however if they shut them down we will be having the whole family round for Xmas festivities instead, the world has gone stark raving mad, have a good one Rick __________________ Ex banger racer now off road maniac Lokka on the front with manual hubs Diff lock on rear 3 inch SS straight through exhaust Manly winch bumper with 13000 lb winch 10 spike ground anchor, with multiple straps and blocks Super strong body cills capped with scaffold pole 20% stronger springs all round aggressive off road tyres on wheels so just swap. Aim to get stuck and be completely self sufficient in extraction, love getting muddy, 2ft deep is good but rare.

04-12-2021, 23:24	#2
solarman216 Off road maniac Join Date: Dec 2009 Location: Bexhill on Sea Vehicle: Y60 Patrol Me, 3 ltr Mrs Posts: 17,431	All set for tomorrow, but had one big issue, when I fitted the off road wheels one of the fronts was flat, some months since I last used them and the problem is they are fitted with tubes and the valve had vanished, had a hunt round for an alternative as the tyre place could not promise to have it done by 5 when they close, found one but it is a Terrano wheel and they need a small mod to fit which we did with Mr angle grinder, then realised that the tyre for the NSF was on the wrong way round, ah well it roles so good enough, then the tyre place rang to say my one was all good, so stuck that in the back as spare, not changing it now, hope to have some nice pics tomorrow, Rick __________________ Ex banger racer now off road maniac Lokka on the front with manual hubs Diff lock on rear 3 inch SS straight through exhaust Manly winch bumper with 13000 lb winch 10 spike ground anchor, with multiple straps and blocks Super strong body cills capped with scaffold pole 20% stronger springs all round aggressive off road tyres on wheels so just swap. Aim to get stuck and be completely self sufficient in extraction, love getting muddy, 2ft deep is good but rare.

05-12-2021, 00:57	#4
solarman216 Off road maniac Join Date: Dec 2009 Location: Bexhill on Sea Vehicle: Y60 Patrol Me, 3 ltr Mrs Posts: 17,431	Yep that's life Pete, that will be a Bosch one, the Zexel is on the timing cover, Rick __________________ Ex banger racer now off road maniac Lokka on the front with manual hubs Diff lock on rear 3 inch SS straight through exhaust Manly winch bumper with 13000 lb winch 10 spike ground anchor, with multiple straps and blocks Super strong body cills capped with scaffold pole 20% stronger springs all round aggressive off road tyres on wheels so just swap. Aim to get stuck and be completely self sufficient in extraction, love getting muddy, 2ft deep is good but rare.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

04-12-2021, 23:32	#3
makeitfit Senior Member Join Date: Apr 2008 Location: on the beach WEST WALES Vehicle: Maverick TDi BLACK mmm Posts: 15,136	I get days like that �� We were ďoing the clutch the other day. All going well you'll I pulled the gearbox back. It felt a little "springy" so the boy gave ne a hand and ping, off it came. The springy was the bloody crank sensor onto of the box �� Wasn't one on the Black Pearl �� Couldn't start the engine, not even any limp mode action �� Found one 30 miles away . Went to get it only gor the bloke selling to snap the bugger taking it out �� Had to buy a new one . So one clutch ,3 days ��

07-12-2021, 16:15	#10
panelbeater Senior Member Join Date: Dec 2012 Location: clacton on sea essex Vehicle: nissan terrano 2 2.7 tdi Posts: 1,638	nice picks rick,did anyone watch Guy in the program to change a fkd disco to a racing one on 5 i think.put a brand new chassis and home built roll cage,good welding and the tracks they raced on and it coped was very amusing tot watch. i do like watching him in his antics.