clutch damper pipe problems

Rocketbirdfishman · 22-08-2016, 18:23

Hello

I've just bought a Nissan terrano II to go on an epic road trip from the UK to Mongolia. My friend has been helping me look over it before the trip and he found the clutch damper pipe has corroded so it needs to be removed. Is it possible to fit a blanking plug into the block on the 3 way join along the clutch pipe and if so does anyone know what size thread the plug needs to be?

Thanks very much

zippy656 · 22-08-2016, 20:31

Quote:

Originally Posted by Rocketbirdfishman

Hello

I've just bought a Nissan terrano II to go on an epic road trip from the UK to Mongolia. My friend has been helping me look over it before the trip and he found the clutch damper pipe has corroded so it needs to be removed. Is it possible to fit a blanking plug into the block on the 3 way join along the clutch pipe and if so does anyone know what size thread the plug needs to be?

Thanks very much

No plug. Just use ball bearing in end of pipe at 3 way join

jims-terrano · 22-08-2016, 22:30

I had to replace the hose at same time so I took the new hose into a bolt specialist who got correct size so yeah you can plug it. I had to get the plug machine with a small concave on the bottom and also used a small rubber o ring. Personally if this happened again I would repair the damper rather than do away with it. Since I blanked it off I get a vibration and a small noise from it.

panelbeater · 24-08-2016, 20:19

lots of stuff on here about damper or no damper.i have one of each and think with is softer without is harder.i had to change the flexipipe on the damped one.

melissachels · 24-08-2016, 23:32

took mine off & welded it shut

22-08-2016, 18:23	#1
Rocketbirdfishman Junior Member Join Date: Aug 2016 Location: Berkshire Vehicle: Nissan Terrano II Posts: 1	clutch damper pipe problems Hello I've just bought a Nissan terrano II to go on an epic road trip from the UK to Mongolia. My friend has been helping me look over it before the trip and he found the clutch damper pipe has corroded so it needs to be removed. Is it possible to fit a blanking plug into the block on the 3 way join along the clutch pipe and if so does anyone know what size thread the plug needs to be? Thanks very much

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

22-08-2016, 22:30	#3
jims-terrano Senior Member Join Date: Sep 2004 Location: UK Posts: 12,965	I had to replace the hose at same time so I took the new hose into a bolt specialist who got correct size so yeah you can plug it. I had to get the plug machine with a small concave on the bottom and also used a small rubber o ring. Personally if this happened again I would repair the damper rather than do away with it. Since I blanked it off I get a vibration and a small noise from it.

24-08-2016, 20:19	#4
panelbeater Senior Member Join Date: Dec 2012 Location: clacton on sea essex Vehicle: nissan terrano 2 2.7 tdi Posts: 1,638	lots of stuff on here about damper or no damper.i have one of each and think with is softer without is harder.i had to change the flexipipe on the damped one.

24-08-2016, 23:32	#5
melissachels Senior Member Join Date: Mar 2012 Location: Near Armagh, Northern Ireland Vehicle: half of a T2 2.7td swb Posts: 1,216	took mine off & welded it shut