Starting problems

Ian Stuart · 14-09-2015, 19:15

Hi
I have a 1999 Nissan Terrano 2.7tdi, I recently did a off the body restoration to my car replaced all the parts with new ones. My problem is that i cannot get the car to run or even turn over. I plugged in a computer to the plug and received the following engine codes.

Code 86: EGRC SOL/V A (0 starts)
Code 88: SOL/V(EGR B&THROT) (0 starts)
Code 88: SOL/V(EGR B&THROT) (0 starts)

Can someone please tell me what these faults are and how to fix them.

The car ran before i started work on it and i have not done anything to the engine.

1 Other thing i cannot find the cam/Crankcase sensor I see a plug for it on the loom but cannot find it on the engine.

Please help

Regards

Ian

Madmark · 14-09-2015, 19:27

Cam\crank sensor if its Bosch is on gearbox bell housing

solarman216 · 14-09-2015, 19:48

if it is Zexel it is on the timing case, and the engine will not run if disconnected, but it should turn over even if you have immobilizer problems it will turn over, so guess you have missed some wires someplace, Rick

14-09-2015, 19:15	#1
Ian Stuart Junior Member Join Date: Sep 2015 Location: Iceland Vehicle: Nissan Terrano 2.7tdi Posts: 1	Starting problems Hi I have a 1999 Nissan Terrano 2.7tdi, I recently did a off the body restoration to my car replaced all the parts with new ones. My problem is that i cannot get the car to run or even turn over. I plugged in a computer to the plug and received the following engine codes. Code 86: EGRC SOL/V A (0 starts) Code 88: SOL/V(EGR B&THROT) (0 starts) Code 88: SOL/V(EGR B&THROT) (0 starts) Can someone please tell me what these faults are and how to fix them. The car ran before i started work on it and i have not done anything to the engine. 1 Other thing i cannot find the cam/Crankcase sensor I see a plug for it on the loom but cannot find it on the engine. Please help Regards Ian

14-09-2015, 19:48	#3
solarman216 Off road maniac Join Date: Dec 2009 Location: Bexhill on Sea Vehicle: Y60 Patrol Me, 3 ltr Mrs Posts: 17,431	if it is Zexel it is on the timing case, and the engine will not run if disconnected, but it should turn over even if you have immobilizer problems it will turn over, so guess you have missed some wires someplace, Rick __________________ Ex banger racer now off road maniac Lokka on the front with manual hubs Diff lock on rear 3 inch SS straight through exhaust Manly winch bumper with 13000 lb winch 10 spike ground anchor, with multiple straps and blocks Super strong body cills capped with scaffold pole 20% stronger springs all round aggressive off road tyres on wheels so just swap. Aim to get stuck and be completely self sufficient in extraction, love getting muddy, 2ft deep is good but rare.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

14-09-2015, 19:27	#2
Madmark Senior Member Join Date: Aug 2014 Location: Dorset Vehicle: highly modded Terrano 2 Posts: 1,088	Cam\crank sensor if its Bosch is on gearbox bell housing