terranno 2001 2.7 SEi faulty speedo & mileometer

red2716 · 25-08-2011, 23:50

Hi Everyone. I have just purchased a teranno 2.7 2001 model and I am a new member.I bought the vehicle with the speedo & mileometer cluster faulty.The rev. counter works ok and everything else appears ok.I am told this is a common fault.I would appreciate any advice on a repair or replacement for this problem.Any other comments on this particular model (Teranno 2.7 SEi+)would be appreciated.I live in East Devon and would be interested to hear from anyone in the area.I hope to become a active member of the club and look forward to taking part in club activities.Regards John.

solarman216 · 26-08-2011, 00:03

Warm welcome mate although I cannot help with the later models, there are plenty on here who can, Rick

Dynamics · 26-08-2011, 00:15

Hello and welcome mate.

Timbo_1975 · 26-08-2011, 08:38

Could you say what exactly is up with the speedo and mileometer please.

If the LCD is displaying rubbish, this is easily fixed. Is the speedo intermittent or completely dead?

rustic · 26-08-2011, 10:46

Quote:

Originally Posted by solarman216

Warm welcome mate although I cannot help with the later models, there are plenty on here who can, Rick

May I repeat what Solarman has said...
Welcome.

There will be a reply along shortly, but often these issues are either poor connections, or a few members have replaced the assembly.
If I recall

there was a an issue with some models during certain years.
Best regards, Rustic

red2716 · 26-08-2011, 12:34

Quote:

Originally Posted by Timbo_1975

Could you say what exactly is up with the speedo and mileometer please.

If the LCD is displaying rubbish, this is easily fixed. Is the speedo intermittent or completely dead?

Hi .Yes the LCD is displaying rubbish and the speedo needle sometimes swings up and down, but more times than not it does nothing. May I say I am already impressed by the club and its members.Hope you can help,thanks again. John

red2716 · 26-08-2011, 12:52

Quote:

Originally Posted by Timbo_1975

Could you say what exactly is up with the speedo and mileometer please.

If the LCD is displaying rubbish, this is easily fixed. Is the speedo intermittent or completely dead?

Hi I don`t know if I managed to reply to Timbo (getting used to site)so I just repeat myself and hope you see this reply.The LCD is complete gibberish and the speedo has a mind of its own but more often than not ,stays at zero.Thanks for the welcome to the club. Regards John

Timbo_1975 · 26-08-2011, 17:08

LCD will be suffering from dry joints and want re-soldering , speedo could either be the head itself -again dry joints- or a bad connection at the gearbox speed sensor.

If you allow the truck to roll forwards with engine at idle, does the idle rpm's jack up when the speedo is dead???

red2716 · 27-08-2011, 13:41

Hi Timbo. I have rolled down the hill in tickover and the revs stay at approx 750 the speedo stays at zero.I have sprayed electrical contact cleaner all round the speedo plug and connections at the gearbox. took it for a run and whilst the speedo is not performing correctly the needle has started to fluctuate alot more.The LCD has a mind of its own, sometimes it displays ok and then it is rubbish.I appreciate all your comments and whilst these are annoying niggles,I am really beginning to enjoy this truck. Regards John

Timbo_1975 · 27-08-2011, 16:36

If the rpms stay constant then the ECU isnt receiving any speed signal from the gearbox sensor, so you'll need to investigate more there. Your speedo will come to life then.

LCD panel just requires resoldering, once you have the instruments out of the dash, it's literally a 30min job, including a lengthy tea break to R+R + solder it!

red2716 · 28-08-2011, 08:57

Hi Timbo.Thanks for all your help and advice.I will let you know the outcome of my efforts,and thanks again.Regards John

harlowmaverick · 28-08-2011, 09:15

apart from your problems, welcome on board!

firebobby · 20-02-2012, 14:29

Quote:

Originally Posted by Timbo_1975

LCD panel just requires resoldering, once you have the instruments out of the dash, it's literally a 30min job, including a lengthy tea break to R+R + solder it!

Hi, I'm new here and have been reading some old post's, great site. I have a 2001 2.7TDI which I have had for 7 years, it has the same problem with the mileage reading...works some times and then gobbledegook, I want to try and repair this as you have stated above, is it obvious which connections need to be re soldered.
I also have a whine in 5th gear,not as bad as a series LR gearbox whine, but it is annoying on a long run, how hard is this to fix and is it common, will it live like this for years or is a problem that needs looking at.
Many thanks for any feedback

25-08-2011, 23:50	#1
red2716 Junior Member Join Date: Aug 2011 Location: south west,East Devon Vehicle: Teranno 11 SE+ 2.7TDi Posts: 13	terranno 2001 2.7 SEi faulty speedo & mileometer Hi Everyone. I have just purchased a teranno 2.7 2001 model and I am a new member.I bought the vehicle with the speedo & mileometer cluster faulty.The rev. counter works ok and everything else appears ok.I am told this is a common fault.I would appreciate any advice on a repair or replacement for this problem.Any other comments on this particular model (Teranno 2.7 SEi+)would be appreciated.I live in East Devon and would be interested to hear from anyone in the area.I hope to become a active member of the club and look forward to taking part in club activities.Regards John.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

26-08-2011, 00:03	#2
solarman216 Off road maniac Join Date: Dec 2009 Location: Bexhill on Sea Vehicle: Y60 Patrol Me, 3 ltr Mrs Posts: 17,431	Warm welcome mate although I cannot help with the later models, there are plenty on here who can, Rick

26-08-2011, 00:15	#3
Dynamics Senior Member Join Date: Jun 2011 Location: Nelson's County Vehicle: TERRANO SWB 2.4 Petrol Posts: 568	Hello and welcome mate.

26-08-2011, 08:38	#4
Timbo_1975 Senior Member Join Date: Apr 2008 Location: S Shropshire Vehicle: Inbetween Terrano's ! Posts: 967	Could you say what exactly is up with the speedo and mileometer please. If the LCD is displaying rubbish, this is easily fixed. Is the speedo intermittent or completely dead?

26-08-2011, 17:08	#8
Timbo_1975 Senior Member Join Date: Apr 2008 Location: S Shropshire Vehicle: Inbetween Terrano's ! Posts: 967	LCD will be suffering from dry joints and want re-soldering , speedo could either be the head itself -again dry joints- or a bad connection at the gearbox speed sensor. If you allow the truck to roll forwards with engine at idle, does the idle rpm's jack up when the speedo is dead???

27-08-2011, 13:41	#9
red2716 Junior Member Join Date: Aug 2011 Location: south west,East Devon Vehicle: Teranno 11 SE+ 2.7TDi Posts: 13	Hi Timbo. I have rolled down the hill in tickover and the revs stay at approx 750 the speedo stays at zero.I have sprayed electrical contact cleaner all round the speedo plug and connections at the gearbox. took it for a run and whilst the speedo is not performing correctly the needle has started to fluctuate alot more.The LCD has a mind of its own, sometimes it displays ok and then it is rubbish.I appreciate all your comments and whilst these are annoying niggles,I am really beginning to enjoy this truck. Regards John

27-08-2011, 16:36	#10
Timbo_1975 Senior Member Join Date: Apr 2008 Location: S Shropshire Vehicle: Inbetween Terrano's ! Posts: 967	If the rpms stay constant then the ECU isnt receiving any speed signal from the gearbox sensor, so you'll need to investigate more there. Your speedo will come to life then. LCD panel just requires resoldering, once you have the instruments out of the dash, it's literally a 30min job, including a lengthy tea break to R+R + solder it!

28-08-2011, 08:57	#11
red2716 Junior Member Join Date: Aug 2011 Location: south west,East Devon Vehicle: Teranno 11 SE+ 2.7TDi Posts: 13	Hi Timbo.Thanks for all your help and advice.I will let you know the outcome of my efforts,and thanks again.Regards John

28-08-2011, 09:15	#12
harlowmaverick Senior Member Join Date: Jun 2009 Location: Harlow, Essex Vehicle: Nissan Terrano 3.0 tdi 03 Posts: 962	apart from your problems, welcome on board!