|
The Clubs Virtual Pub For general chat, so come on in and pull up a chair. |
|
Thread Tools | Display Modes |
03-12-2017, 12:53 | #16 |
Off road maniac
Join Date: Dec 2009
Location: Bexhill on Sea
Vehicle: Y60 Patrol Me, 3 ltr Mrs
Posts: 17,431
|
And more, not sure how much of this I will sort today, some is quite slow to do, but need to separate the stainless from all other metals to get the best price, Rick
__________________
Ex banger racer now off road maniac Lokka on the front with manual hubs Diff lock on rear 3 inch SS straight through exhaust Manly winch bumper with 13000 lb winch 10 spike ground anchor, with multiple straps and blocks Super strong body cills capped with scaffold pole 20% stronger springs all round aggressive off road tyres on wheels so just swap. Aim to get stuck and be completely self sufficient in extraction, love getting muddy, 2ft deep is good but rare. |
03-12-2017, 13:09 | #17 |
Senior Member
Join Date: Sep 2004
Location: UK
Posts: 12,965
|
You have your work it out there Rick.
I’m just mustering the enthusiasm to nip out to the truck and give it a little more waxoyl before putting wheel back on and moving it. If I can be bothered I’ll jack it up and cut some more rot out but I’ll need to be able to move it again tomorrow morning to make room for the oven being delivered. |
03-12-2017, 21:29 | #18 |
Off road maniac
Join Date: Dec 2009
Location: Bexhill on Sea
Vehicle: Y60 Patrol Me, 3 ltr Mrs
Posts: 17,431
|
Well got a trailer load ready to go tomorrow if I have time, all iron apart from the black tank full of copper, Rick
__________________
Ex banger racer now off road maniac Lokka on the front with manual hubs Diff lock on rear 3 inch SS straight through exhaust Manly winch bumper with 13000 lb winch 10 spike ground anchor, with multiple straps and blocks Super strong body cills capped with scaffold pole 20% stronger springs all round aggressive off road tyres on wheels so just swap. Aim to get stuck and be completely self sufficient in extraction, love getting muddy, 2ft deep is good but rare. |
03-12-2017, 21:40 | #19 |
Senior Member
Join Date: Sep 2004
Location: UK
Posts: 12,965
|
Not sure how much the iron will be worth much but you should get a little for the copper, every little as they say
|
03-12-2017, 21:59 | #20 |
Off road maniac
Join Date: Dec 2009
Location: Bexhill on Sea
Vehicle: Y60 Patrol Me, 3 ltr Mrs
Posts: 17,431
|
The copper should fetch around £200 the iron probably less than a tonne so about £45, we will see when I take it over, only about a ten mile round trip, Rick
__________________
Ex banger racer now off road maniac Lokka on the front with manual hubs Diff lock on rear 3 inch SS straight through exhaust Manly winch bumper with 13000 lb winch 10 spike ground anchor, with multiple straps and blocks Super strong body cills capped with scaffold pole 20% stronger springs all round aggressive off road tyres on wheels so just swap. Aim to get stuck and be completely self sufficient in extraction, love getting muddy, 2ft deep is good but rare. |
03-12-2017, 22:16 | #21 |
Senior Member
Join Date: Sep 2016
Location: Portsmouth Hampshire
Vehicle: Nissan patrol 3.0 DI
Posts: 638
|
Well I’ve had an interesting few days. On Wednesday I went into hospital to have a total hip replacement, on Thursday morning it had dislocated its self so back down to theatre to have it put back. Well I’m back home now and resting but really BORED. Hospital food was ok as I was in a private ward but on the nhs so it was a quite pleasant experience when I have the other leg done next year I hope I’m in the same ward. So that’s my few days this week.
|
04-12-2017, 10:00 | #22 |
Moderator
Join Date: Jul 2012
Location: West Midlands
Vehicle: 04 2.7 SWB Terrano II Van
Posts: 13,526
|
__________________
Moderator 04' Terrano II SE 2.7 TDi SWB Commercial in Silver - Project Thread Toyo Open Country M/T 33's on 10J Steels, Super Strong Steering Job Navara D22 Snorkel, Front LOKKA, Maunal Hubs, EGR Blank TunitII ECU Chip, 3" Body Lift, 2" Suss Lift, Heat Exchanger Black Interior, 3.0 Borg&Beck Clutch, Eckes Heated Fuel Filter 99' Y61 Patrol GR SE 2.8 TD6 LWB in Blue/Silver - Project Thread Engine Transplant - In Progress!!! |
04-12-2017, 10:04 | #23 |
Moderator
Join Date: Jul 2012
Location: West Midlands
Vehicle: 04 2.7 SWB Terrano II Van
Posts: 13,526
|
Bloody hell Rick!!!! Or should I say Steptoe
__________________
Moderator 04' Terrano II SE 2.7 TDi SWB Commercial in Silver - Project Thread Toyo Open Country M/T 33's on 10J Steels, Super Strong Steering Job Navara D22 Snorkel, Front LOKKA, Maunal Hubs, EGR Blank TunitII ECU Chip, 3" Body Lift, 2" Suss Lift, Heat Exchanger Black Interior, 3.0 Borg&Beck Clutch, Eckes Heated Fuel Filter 99' Y61 Patrol GR SE 2.8 TD6 LWB in Blue/Silver - Project Thread Engine Transplant - In Progress!!! |
04-12-2017, 10:18 | #24 |
Senior Member
Join Date: Feb 2008
Location: Aflreton,Derbyshire.
Vehicle: 2000se+ 2.7tdi terrano II
Posts: 6,832
|
|
04-12-2017, 20:38 | #25 |
Off road maniac
Join Date: Dec 2009
Location: Bexhill on Sea
Vehicle: Y60 Patrol Me, 3 ltr Mrs
Posts: 17,431
|
Pleasant surprise
Well well well, I am happy, £237.60 for the copper, £117.80 for the iron, it has gone up to £95 a Tonne, and S/S is now £600 !!!! will be putting that on the trailer soon, Rick
__________________
Ex banger racer now off road maniac Lokka on the front with manual hubs Diff lock on rear 3 inch SS straight through exhaust Manly winch bumper with 13000 lb winch 10 spike ground anchor, with multiple straps and blocks Super strong body cills capped with scaffold pole 20% stronger springs all round aggressive off road tyres on wheels so just swap. Aim to get stuck and be completely self sufficient in extraction, love getting muddy, 2ft deep is good but rare. |
04-12-2017, 20:51 | #26 |
Senior Member
Join Date: Mar 2014
Location: Welcome to Norwich, a fine city
Vehicle: 2004 Terrano 3.0 SVE Auto
Posts: 3,601
|
Kerching!
You know what they. One man's shite is another man's brass worth 2 in a bush spoiling the broth |
04-12-2017, 22:29 | #27 |
Senior Member
Join Date: Sep 2004
Location: UK
Posts: 12,965
|
Flipping heck that’s good Rick, I have a tub full of copper pipe off cuts but never been bothered to take it in.
|
05-12-2017, 00:07 | #28 |
Off road maniac
Join Date: Dec 2009
Location: Bexhill on Sea
Vehicle: Y60 Patrol Me, 3 ltr Mrs
Posts: 17,431
|
Here it is £3.60 per Kg at the mo Rick
__________________
Ex banger racer now off road maniac Lokka on the front with manual hubs Diff lock on rear 3 inch SS straight through exhaust Manly winch bumper with 13000 lb winch 10 spike ground anchor, with multiple straps and blocks Super strong body cills capped with scaffold pole 20% stronger springs all round aggressive off road tyres on wheels so just swap. Aim to get stuck and be completely self sufficient in extraction, love getting muddy, 2ft deep is good but rare. |
05-12-2017, 00:25 | #29 |
Senior Member
Join Date: Sep 2004
Location: UK
Posts: 12,965
|
Will have to dig all the copper out sometime and weigh it in but for the moment my plate is well and truly full to over flowing. One job at a time for me at the moment.
|
05-12-2017, 10:23 | #30 |
Senior Member
Join Date: Sep 2010
Location: Mid-Wales
Vehicle: Maverick 2.7 - Patrol 4.2
Posts: 5,645
|
I went airsofting for the first time near cosford, Great fun was had but my legs are aching now.
|
Thread Tools | |
Display Modes | |
|
|