Latest project started Monday to keep me busy

[solarman216]

Close up

[solarman216]

Floor tiles

[solarman216]

Disabled WC part tilled

[solarman216]

Ladies WC being tilled, all for now Rick

[solarman216]

Originally Posted by rayf3262

This is the type of differential pressure switch we use at the University on extract and AHU's. One 6mm tube either side of of the fan.
http://uk.rs-online.com/web/p/produc...xoCL0UQAvD_BwE

The controller I have been supplied with is simply a diff pressure sensor that detects lower pressure in the canopy side of the fan together with a current draw to the fan, yet to get a gas control valve till I know what size pipe I will be using, Rick

[terranosaurusdoug]

Originally Posted by solarman216

Bought a 50 Mtr roll off pipe earlier in the week, unwrapped it today with the intention of running it through a narrow ceiling void, only to find it is 15 mm not 22, so that job was abandoned

Yeah blue for 15 and purple-ish for 22.

[solarman216]

Originally Posted by terranosaurusdoug

Yeah blue for 15 and purple-ish for 22.

Thanks mate, do not buy enough to know that, but good that my pic shows that so can argue tomorrow against an invoice for 22mm, Rick

[terranosaurusdoug]

Originally Posted by solarman216

Thanks mate, do not buy enough to know that, but good that my pic shows that so can argue tomorrow against an invoice for 22mm, Rick

Should be unmistakable to anyone who works in a merchants

[solarman216]

Originally Posted by terranosaurusdoug

Should be unmistakable to anyone who works in a merchants

My local I am afraid are not the best but I get good terms so put up with it, I still have a 10k limit although mostly I only spend a couple of hundred, Rick

[solarman216]

The only bit of CH pipe seen on supply run to raised deck area apart from feeds to rads

[solarman216]

Rear shelving of bar etc

[solarman216]

Next WC stripped and to be tilled

[solarman216]

Corridor to wash area started white board so lecy could mount light switch

[solarman216]

From wash area to kitchen, getting a bit tight for space now, lots done this week but not too much for good pics, 3 weeks left, just done a recy on what is left to do! lecy can cope, Dave and his lads as well (lots to do but there are 4 of them) Data/security guy has it easy, I can cope with gas, domestic plumbing, air con for beer cellar, ducting for canopy and full heating plus sorting other trades problems, the grey area is the tilers, at their current rate of progress they stand no chance, in total we have over 5 tonnes of ceramic tiles to lay/apply so far they have not even completed one WC, words next week, , all this week Rick

[solarman216]

No pics today, just too much going on, just seen the WC basins and taps etc, cannot wait to be fitting those, started running gas pipe 42 mm from meter to ceiling void where it will be accessible, then drop down to 35 mm, if they add further gas appliances later then it will be easy to upgrade to 42 all the way but at this time have to look at cost, 42 pipe is not cheap, I was asked today about 1.5 inch black iron barrel, problem is it comes red oxide painted, no good at all, owner has found it on the net, need 100 x .900 mm pieces & 200 floor plates this is for the balustrade around the raised seating area, tillers recon they have up to ten guys available, with less than 3 weeks left they may need them, hope to have some progress pics tomorrow, Rick