I need these - Page 2

solarman216 · 13-07-2021, 20:35

And for the benefit of FT, this is where the 6 bolt dust seal rubs on the hub, guess this will not be so on the Y61, but for me it does give added protection from Slindon mud, Rick

solarman216 · 14-07-2021, 00:49

Sadly I cannot get that in my lathe to get rid of that groove made by the old seal so a drill powered wire brush will have to do, Rick

Flying Torquewrench · 14-07-2021, 11:50

No, on the Y61 there is more then enough clearance between the grease catcher and the hub. Wonder why they changed the design between the two models.

solarman216 · 14-07-2021, 20:34

These arrived today, shaft seals tomorrow maybe, Rick

solarman216 · 16-07-2021, 23:31

Lovely new shaft seals arrived today so all set now to complete the NS drive shaft job but has taken a back seat to the pump issue, Rick

14-07-2021, 00:49	#17
solarman216 Off road maniac Join Date: Dec 2009 Location: Bexhill on Sea Vehicle: Y60 Patrol Me, 3 ltr Mrs Posts: 17,431	Sadly I cannot get that in my lathe to get rid of that groove made by the old seal so a drill powered wire brush will have to do, Rick __________________ Ex banger racer now off road maniac Lokka on the front with manual hubs Diff lock on rear 3 inch SS straight through exhaust Manly winch bumper with 13000 lb winch 10 spike ground anchor, with multiple straps and blocks Super strong body cills capped with scaffold pole 20% stronger springs all round aggressive off road tyres on wheels so just swap. Aim to get stuck and be completely self sufficient in extraction, love getting muddy, 2ft deep is good but rare.

16-07-2021, 23:31	#20
solarman216 Off road maniac Join Date: Dec 2009 Location: Bexhill on Sea Vehicle: Y60 Patrol Me, 3 ltr Mrs Posts: 17,431	Lovely new shaft seals arrived today so all set now to complete the NS drive shaft job but has taken a back seat to the pump issue, Rick __________________ Ex banger racer now off road maniac Lokka on the front with manual hubs Diff lock on rear 3 inch SS straight through exhaust Manly winch bumper with 13000 lb winch 10 spike ground anchor, with multiple straps and blocks Super strong body cills capped with scaffold pole 20% stronger springs all round aggressive off road tyres on wheels so just swap. Aim to get stuck and be completely self sufficient in extraction, love getting muddy, 2ft deep is good but rare.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

14-07-2021, 11:50	#18
Flying Torquewrench Senior Member Join Date: May 2011 Location: Worcestershire Vehicle: Nissan Patrol Y61 2.8TD Posts: 1,152	No, on the Y61 there is more then enough clearance between the grease catcher and the hub. Wonder why they changed the design between the two models.