01-04-2016, 22:52 | #1 |
Senior Member
Join Date: Apr 2008
Location: on the beach WEST WALES
Vehicle: Maverick TDi BLACK mmm
Posts: 15,136
|
4 post lift
Today I are been mainly collecting me 4 post Lift
Poor old Vito had it's work cut out today . It's got lowered suspension and that's why the trailer is low at the front, the hitch is inches off ploughing the tarmac Plenty of elf n safety tape just to show willing Not sure how wide one is allowed but 2.95m tends to concentrate the mind a bit So once re-assembled it should look like this Black Pearl development will be rad now |
01-04-2016, 23:13 | #2 |
Senior Member
Join Date: Apr 2014
Location: Just north of Ipswich, Suffolk
Vehicle: Terrano II 2.7 SE+ Auto
Posts: 1,094
|
V Nice
|
01-04-2016, 23:28 | #3 |
Off road maniac
Join Date: Dec 2009
Location: Bexhill on Sea
Vehicle: Y60 Patrol Me, 3 ltr Mrs
Posts: 17,431
|
Very nice, did you lose your rear number plate? Rick
__________________
Ex banger racer now off road maniac Lokka on the front with manual hubs Diff lock on rear 3 inch SS straight through exhaust Manly winch bumper with 13000 lb winch 10 spike ground anchor, with multiple straps and blocks Super strong body cills capped with scaffold pole 20% stronger springs all round aggressive off road tyres on wheels so just swap. Aim to get stuck and be completely self sufficient in extraction, love getting muddy, 2ft deep is good but rare. |
01-04-2016, 23:36 | #4 |
Senior Member
Join Date: Sep 2004
Location: UK
Posts: 12,965
|
You lucky sod
|
01-04-2016, 23:39 | #5 |
Senior Member
Join Date: Apr 2008
Location: on the beach WEST WALES
Vehicle: Maverick TDi BLACK mmm
Posts: 15,136
|
|
01-04-2016, 23:41 | #6 |
Senior Member
Join Date: Apr 2008
Location: on the beach WEST WALES
Vehicle: Maverick TDi BLACK mmm
Posts: 15,136
|
|
02-04-2016, 00:07 | #7 |
Senior Member
Join Date: Jan 2011
Location: southwest gloucester
Vehicle: Nissan Terrano 2.7 2003
Posts: 615
|
i have a similar ramp as yours mine is a bradbury lift master 2 and has the wheel free system but apart from that is identical good strong ramp
|
02-04-2016, 00:10 | #8 | |
Senior Member
Join Date: Apr 2008
Location: on the beach WEST WALES
Vehicle: Maverick TDi BLACK mmm
Posts: 15,136
|
Quote:
Just ggoooogggling instructions for it now |
|
02-04-2016, 07:30 | #9 |
Senior Member
Join Date: Oct 2014
Location: South west
Vehicle: Terrano
Posts: 522
|
I have the slide along beam jack thingy for mine but it needs new seals I will have to get it repaired as they seem to fetch good money at auctions so I wont be replacing it.
|
02-04-2016, 09:51 | #10 |
Senior Member
Join Date: Jan 2011
Location: southwest gloucester
Vehicle: Nissan Terrano 2.7 2003
Posts: 615
|
yes they did and most beam jacks are adjustable to fit four post ramps has sliders on jack that you extend to your ramp size then tighten adjuster bolts to secure then it just rolls along the ramp i have a sliding beam jack for mine very useful with the the wheel free i find it great for removing the terrano gearbox as i leave the terrano on the wheel free beams and then slide a couple of planks across and then lower the gearbox out on beam jack and on to the planks then lower the ramp to the floor with no effort at all
|
02-04-2016, 20:06 | #11 |
Moderator
Join Date: Jul 2012
Location: West Midlands
Vehicle: 04 2.7 SWB Terrano II Van
Posts: 13,526
|
And here's me happy with my poxy little garage
I need somewhere big enough for this!!!!
__________________
Moderator 04' Terrano II SE 2.7 TDi SWB Commercial in Silver - Project Thread Toyo Open Country M/T 33's on 10J Steels, Super Strong Steering Job Navara D22 Snorkel, Front LOKKA, Maunal Hubs, EGR Blank TunitII ECU Chip, 3" Body Lift, 2" Suss Lift, Heat Exchanger Black Interior, 3.0 Borg&Beck Clutch, Eckes Heated Fuel Filter 99' Y61 Patrol GR SE 2.8 TD6 LWB in Blue/Silver - Project Thread Engine Transplant - In Progress!!! |
03-04-2016, 07:59 | #12 |
Senior Member
Join Date: Oct 2014
Location: South west
Vehicle: Terrano
Posts: 522
|
|
Thread Tools | |
Display Modes | |
|
|