Dirty electrics.?

CLEANS: WD-40 gets under dirt, marks and grease making it easy to wipe away. It also dissolves adhesives, allowing easy removal of labels, tape, and stickers
PROTECTS: WD-40 protects metal surfaces with corrosion-resistant ingredients to shield against moisture and other corrosive elements
LUBRICATES: WD-40\'s lubricating ingredients are widely dispersed and hold firmly to all moving parts
PENETRATES: WD-40 loosens rust-to-metal bonds and frees stuck, frozen or rusted metal parts
DISPLACES MOISTURE: Because WD-40 displaces moisture, it quickly dries out electrical systems to eliminate moisture-induced short circuits. Turn the power off before you spray

Adz · 04-07-2009, 18:53

So you have a tow bar with electrics
&
You have a caravan,trailer,dolly or board
You know it all works but have trouble time to time with lights not working but the bulbs are ok

Well...

That will be a thing of the past thanks to this top tip

200ml of any brand washing up liquid.
200ml of any brand viniger.
400ml of boiled water (any brand

).
Place/poor all 3 into a triger bottle squiter.

Spray the terminals on both plugs then open the terminals with a flat headed screw driver & spray again till all the rubish comes out...wait 10 mins...

Spray again with luke warm water & leave to dry...

Job done

Nice clean terminals & no loose conection

Hope this helps someone

04-07-2009, 18:53	#1
Adz Senior Member Join Date: May 2009 Location: Roaming Nomad Vehicle: 1995 SWB Terrano Posts: 5,370	Dirty electrics.? So you have a tow bar with electrics & You have a caravan,trailer,dolly or board You know it all works but have trouble time to time with lights not working but the bulbs are ok Well... That will be a thing of the past thanks to this top tip 200ml of any brand washing up liquid. 200ml of any brand viniger. 400ml of boiled water (any brand ). Place/poor all 3 into a triger bottle squiter. Spray the terminals on both plugs then open the terminals with a flat headed screw driver & spray again till all the rubish comes out...wait 10 mins... Spray again with luke warm water & leave to dry... Job done Nice clean terminals & no loose conection Hope this helps someone