Hi

Remimax · 06-11-2019, 20:15

got an old terrano 99 plate ,had it a few years,needed a fair bit of welding but all done inhouse.use it as a shooting bus.
currently she is sick and will not start.think she has the dreaded curse of the NATS 2 lock out. had a prob with heater plugs slow going off traced to an iffy temp stat ,would run battery down over time.
anyway got new fault now ,has run ok for about 6 months.
went to it in the morning, battery a bit flat failed to start after 3 goes think its locked out.
its done this before and after being left for a while and recharged away she goes,but not this time.been a month now and pulling me hair out ,replaced crank sensor still same,no tacho bounce on engine crank,nats light goes out when you put key in and krank ,doors work on the fob,getting dc supply to fuel solenoid on cranking,and had it out and it works with jumper leads,heater plugs are on a switch to operate relay.kicks on easy start.had pump banjo off filter is clean .run out of ideas.
was starting running fine day before it died.
anyone got any ideas.

06-11-2019, 20:15	#1
Remimax Junior Member Join Date: Nov 2019 Location: wales Vehicle: terrano 2 Posts: 4	Hi got an old terrano 99 plate ,had it a few years,needed a fair bit of welding but all done inhouse.use it as a shooting bus. currently she is sick and will not start.think she has the dreaded curse of the NATS 2 lock out. had a prob with heater plugs slow going off traced to an iffy temp stat ,would run battery down over time. anyway got new fault now ,has run ok for about 6 months. went to it in the morning, battery a bit flat failed to start after 3 goes think its locked out. its done this before and after being left for a while and recharged away she goes,but not this time.been a month now and pulling me hair out ,replaced crank sensor still same,no tacho bounce on engine crank,nats light goes out when you put key in and krank ,doors work on the fob,getting dc supply to fuel solenoid on cranking,and had it out and it works with jumper leads,heater plugs are on a switch to operate relay.kicks on easy start.had pump banjo off filter is clean .run out of ideas. was starting running fine day before it died. anyone got any ideas.