wanted - EGR blanking plate

clivvy · 10-09-2012, 20:59

yes Ryan, it really is that simple. a little awkward as far as I can see, but i had a good look at the weekend, and i reckon it can be done through the top using a thin but decent quality long wrench, 1/4" so it will fit. Two bolts, slide in the blanking plate, bolt back up. MIGHT have to loosen off at the exhaust side for movement, im not 100% sure yet, but shouldnt be too tricky if that is the case.

Peter, yes, i emailed the chap, he doesnt have any, and can only make one if i can get the dimensions ?!

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

10-09-2012, 20:59	#23
clivvy Senior Member Join Date: Mar 2009 Location: Huddersfield Vehicle: Terrano 03 LWB Posts: 6,947	yes Ryan, it really is that simple. a little awkward as far as I can see, but i had a good look at the weekend, and i reckon it can be done through the top using a thin but decent quality long wrench, 1/4" so it will fit. Two bolts, slide in the blanking plate, bolt back up. MIGHT have to loosen off at the exhaust side for movement, im not 100% sure yet, but shouldnt be too tricky if that is the case. Peter, yes, i emailed the chap, he doesnt have any, and can only make one if i can get the dimensions ?!