really want 33's

[davis8008]

hello iv used the search bar but can't seem to find what im looking for? Anyway im seriously looking in to fitting 33's on my lwb terrano but dont know what works involved to do it properly, I was looking at getting some 15" steel wheels from here http://www.extremeoffsetwheels.com/page4.html would I need 35mm off set or 50mm? also what a bout gearing? will a remap sort that out? and ive done a body lift was going to do a 2" suspension lift too! im sure I might have missed some other stuff? thanks in advance for any advice

[stinka]

Offset of Neg 15 or neg 25 better still

[makeitfit]

Re-map or power chip will defo help

[davis8008]

im on the right tracks then.......

ive seen people on here talking about making there steering stronger or something when running 35's will I need to do this with 33's? if so whats involved?

[stinka]

http://www.nissan4x4ownersclub.com/f...ad.php?t=18642

[davis8008]

Thanks

[Fez_uk]

Originally Posted by davis8008

im on the right tracks then.......

ive seen people on here talking about making there steering stronger or something when running 35's will I need to do this with 33's? if so whats involved?

You will need it for 31s and upwards if you do a fair amount of offroading.

[makeitfit]

Originally Posted by stinka

http://www.nissan4x4ownersclub.com/f...ad.php?t=18642

You could at least have put a link to the quality version of that mod, like mine

[davis8008]

whats the link for the "quality version" ?? ive just done a search and gone through 19 pages of results but couldn't fine much else about them

[stinka]

Originally Posted by makeitfit

You could at least have put a link to the quality version of that mod, like mine

Aye its not pretty, but its fully sealed and tough as owt

[stinka]

Originally Posted by davis8008

whats the link for the "quality version" ?? ive just done a search and gone through 19 pages of results but couldn't fine much else about them

There's no guide for this mod, its a case of getting a box, stripping it, cut the back and side off, cut the gear off the shaft, then riveting a plate on with loads of tiger seal under it. Fill it with grease before you plate it up tho

[stinka]

Like this :

[davis8008]

you've totally lost me now, wish I was better with cars..........

[stinka]

Originally Posted by davis8008

you've totally lost me now, wish I was better with cars..........

Makeitfit will do you one if he still does them, ready to bolt on £200 I think