Go Back   :::.Nissan 4x4 Owners Club.::: > General > The Clubs Virtual Pub

The Clubs Virtual Pub For general chat, so come on in and pull up a chair.

Reply
 
Thread Tools Display Modes
Old 26-12-2018, 01:31   #1
Wallace
Senior Member
Click here to find out how to become a paid up member
 
Join Date: Aug 2018
Location: Middlesex
Vehicle: '97 Terrano II 2.4 Xtreme
Posts: 368
Default Christmas Day Workshop Time?

Who sneaked out and what did you do?

While everyone else went for kids present opening at one of the Stepsons houses I did my chores left for me written on a PostIt note and hit the workshop with a mild hangover.

I partially reassembled a scooter that needs more parts and money spent than it's worth and parked it outside with a cover over and rolled the bike bench under one of the cars in my Transport museum. Scooter needs a fork yoke as a bare minimum if not a frame........See photo I tried to re-orientate 3 times in various ways.

Swept up, cleared the tools away and then refitted the rear seat squabs I took out to get a freebie bench in the back. Had a bit of a sniff round to see where the wet dog smell is coming from and took all the over mats out. Close inspection shows Terrier hair embedded in the upholstery that must be pre 2005 before my friend bought the car and it does have damp areas inside.

Bought the car inside and shut up shop as the tribe came home for present time. #
Attached Images
File Type: jpg IMG_6042.jpg (54.3 KB, 61 views)
Wallace is offline   Reply With Quote
Old 26-12-2018, 02:08   #2
Banshee
Moderator
 
Banshee's Avatar
 
Join Date: Jul 2012
Location: West Midlands
Vehicle: 04 2.7 SWB Terrano II Van
Posts: 13,526
Default

Good man!!! I was up early this morn to go and see my Nan & Grandad with my brother and sister before she was collected for Xmas dinner at my Uncles house this year.

Then back over to Solihull to an Xmas dinner and a day with the girlfriends family and didn't get home until 10:30pm the worst part about it I haven't even opened any presents yet from the girlfriend We're doing ours in the morning

So upon arrival at Banshee HQ I dipped straight off into the garage to do a few jobs, I've been fettling with more insulation for the underneath of the rubber floor cover for my Commercial and then sprayed a few more plastic bits with Vinyl Dye, then I just put some music on in there and had a tidy up and relaxed.

I needed to get back to my garage, I feel at peace in there and hate being hemmed inside with no fresh air.
__________________
Moderator

04' Terrano II SE 2.7 TDi SWB Commercial in Silver - Project Thread
Toyo Open Country M/T 33's on 10J Steels, Super Strong Steering Job
Navara D22 Snorkel, Front LOKKA, Maunal Hubs, EGR Blank
TunitII ECU Chip, 3" Body Lift, 2" Suss Lift, Heat Exchanger
Black Interior, 3.0 Borg&Beck Clutch, Eckes Heated Fuel Filter


99' Y61 Patrol GR SE 2.8 TD6 LWB in Blue/Silver - Project Thread
Engine Transplant - In Progress!!!
Banshee is offline   Reply With Quote
Old 26-12-2018, 02:24   #3
Lazy-Ferret
Senior Member
Click here to find out how to become a paid up member
 
Join Date: Jun 2012
Location: Sevenoaks, Kent
Vehicle: Terrano 2.7TDi SE Touring
Posts: 5,221
Default

My wife went for a theme this year, I got the car, then a Train, and when I mentioned the classic Christmas film, "Trains, Planes and Automobiles", she did this!!







Since the Plane was already assembled, I set to work making the Train..





Lazy-Ferret is offline   Reply With Quote
Old 26-12-2018, 02:53   #4
Banshee
Moderator
 
Banshee's Avatar
 
Join Date: Jul 2012
Location: West Midlands
Vehicle: 04 2.7 SWB Terrano II Van
Posts: 13,526
Default

Nice one Clive
__________________
Moderator

04' Terrano II SE 2.7 TDi SWB Commercial in Silver - Project Thread
Toyo Open Country M/T 33's on 10J Steels, Super Strong Steering Job
Navara D22 Snorkel, Front LOKKA, Maunal Hubs, EGR Blank
TunitII ECU Chip, 3" Body Lift, 2" Suss Lift, Heat Exchanger
Black Interior, 3.0 Borg&Beck Clutch, Eckes Heated Fuel Filter


99' Y61 Patrol GR SE 2.8 TD6 LWB in Blue/Silver - Project Thread
Engine Transplant - In Progress!!!
Banshee is offline   Reply With Quote
Old 26-12-2018, 06:45   #5
jims-terrano
Senior Member
Click here to find out how to become a paid up member
 
Join Date: Sep 2004
Location: UK
Posts: 12,965
Default

I did virtually nothing at all, thought a lot about my projects but thinking along the lines of off loading all my projects such as the MG and common sense dictates one of the Terranos too. So making plans for that so just mentally doing jobs rather than physically doing anything.
jims-terrano is offline   Reply With Quote
Old 26-12-2018, 10:01   #6
Davey Boy
Senior Member
Click here to find out how to become a paid up member
 
Join Date: Dec 2015
Location: Dartmoor
Vehicle: Patrol ZD30 SVE
Posts: 960
Default

A good result comes from 80% thinking/20% doing Jim.
You've done the right thing. Haha
Davey Boy is offline   Reply With Quote
Old 26-12-2018, 10:26   #7
Wheelie
Senior Member
Click here to find out how to become a paid up member
 
Join Date: Sep 2016
Location: Portsmouth Hampshire
Vehicle: Nissan patrol 3.0 DI
Posts: 638
Default

I won't allow myself to think about doing anymore to the troll, because if I think about something it tends to cost me money

Sent from my SM-A520F using Tapatalk
Wheelie is offline   Reply With Quote
Old 26-12-2018, 10:35   #8
macabethiel
Senior Member
Click here to find out how to become a paid up member
 
Join Date: Aug 2008
Location: Derby
Vehicle: Freelander & Jeep GC 3.0
Posts: 4,416
Thumbs down Both laid low with Christmas Cold type bug.

We started feeling crap on Christmas eve, yesterday we did not have Christmas Dinner as we just could not face eating much - ended up with a Beefburger in a Bun!

Today all aches & pains suitably drugged up with Soluble Solpadeine. Crap
macabethiel is offline   Reply With Quote
Old 26-12-2018, 17:04   #9
johnb5177
Senior Member
Click here to find out how to become a paid up member
 
Join Date: Sep 2013
Location: Swansea, S.Wales
Vehicle: 02Terrano II 3.0 SVE Auto
Posts: 1,586
Default

A very quiet day yesterday, just the 2 of us....

Today was stuffed, as we fancied a walk, even in the grey damp day it is, but then realise, my permanent nightmare beckoned.......the bloody faulty window regulator on SWMBO's Renault Megane........

A built in design flaw, that Renault belatedly acknowledged years later, then told everyone to p##s off, allows water ingress down the window glass, and blows the 'temic' module (regulates the window winder mechanism).......this will be the 4th one I've tried to replace/repair, on a 05 car with less than 70k on the clock.

Replacement modules are inexpensive from fleabay, but a royal pain removing the door card......and the amount of corrosion in the main loom plug into this, means a new plug, soldered onto the old leads....ggggrrrrrrr

So window is locked down, plastic sheet and duck tape over the large hole, and she has to borrow the tractor or use the bus, until I get it fix ASAP after new years day !!!!!!!

So, I think it will be a few 'Nelson's Bloods' for me tonight in recompense for a stuffed up day.......
johnb5177 is offline   Reply With Quote
Old 27-12-2018, 10:15   #10
Wallace
Senior Member
Click here to find out how to become a paid up member
 
Join Date: Aug 2018
Location: Middlesex
Vehicle: '97 Terrano II 2.4 Xtreme
Posts: 368
Default

Quote:
Originally Posted by johnb5177 View Post

Replacement modules are inexpensive from fleabay, but a royal pain removing the door card......and the amount of corrosion in the main loom plug into this, means a new plug, soldered onto the old leads....ggggrrrrrrr
Annoying when the reset procedure doesn't work! I like the MkV Golf where you remove the door skin to access the inner gubbins, neat idea and good for bodywork repairs. Then again, if the motors and door locks were better built and lasted longer than a set of spark plugs.......
Wallace is offline   Reply With Quote
Old 27-12-2018, 22:02   #11
Wallace
Senior Member
Click here to find out how to become a paid up member
 
Join Date: Aug 2018
Location: Middlesex
Vehicle: '97 Terrano II 2.4 Xtreme
Posts: 368
Default

Spent some more time on the Terrano today in between fixing other peoples junk.

Bit more welding on the housing then flush the block and radiator out. Thermostat and housing are now fitted to the engine with stainless cap heads. Checked the old and new thermostats in hot water, old one opens slightly quicker than the new one and does open fully which isn't what I was expecting to see. I'm still in head gasket denial.

Block flush was surprisingly clean as was the radiator but the flow through the radiator didn't seem very good. As the thermostat seemed to be ok perhaps the radiator is partially blocked causing the temperature to rise in traffic. Ended up taking the bottom tank off the radiator and rodding each tube, now have a good clear flow through all but 1 tube that seems to have a manufacturing defect.

I will try running the car tomorrow with the viscous fan and see if the symptoms have improved then look at fitting the electric fans.
Wallace is offline   Reply With Quote
Old 28-12-2018, 21:11   #12
solarman216
Off road maniac
Click here to find out how to become a paid up member
 
solarman216's Avatar
 
Join Date: Dec 2009
Location: Bexhill on Sea
Vehicle: Y60 Patrol Me, 3 ltr Mrs
Posts: 17,431
Default

Been advancing our new utility room, worktops cut and machined, water pipe for two washing machines and table top dish washer in cable run in ready for electrics, more hopefully tomorrow unless I get a call, Rick
Attached Images
File Type: jpg DSCN5702.jpg (44.6 KB, 35 views)
__________________
Ex banger racer now off road maniac
Lokka on the front with manual hubs
Diff lock on rear
3 inch SS straight through exhaust
Manly winch bumper with 13000 lb winch
10 spike ground anchor, with multiple straps and blocks
Super strong body cills capped with scaffold pole
20% stronger springs all round
aggressive off road tyres on wheels so just swap.
Aim to get stuck and be completely self sufficient in extraction, love getting muddy, 2ft deep is good but rare.
solarman216 is offline   Reply With Quote
Old 30-12-2018, 23:28   #13
solarman216
Off road maniac
Click here to find out how to become a paid up member
 
solarman216's Avatar
 
Join Date: Dec 2009
Location: Bexhill on Sea
Vehicle: Y60 Patrol Me, 3 ltr Mrs
Posts: 17,431
Default

How it looks today but might turn it around as not happy with tumble drier pos, Rick
Attached Images
File Type: jpg DSCN5705.jpg (51.3 KB, 25 views)
__________________
Ex banger racer now off road maniac
Lokka on the front with manual hubs
Diff lock on rear
3 inch SS straight through exhaust
Manly winch bumper with 13000 lb winch
10 spike ground anchor, with multiple straps and blocks
Super strong body cills capped with scaffold pole
20% stronger springs all round
aggressive off road tyres on wheels so just swap.
Aim to get stuck and be completely self sufficient in extraction, love getting muddy, 2ft deep is good but rare.
solarman216 is offline   Reply With Quote
Old 30-12-2018, 23:59   #14
Wallace
Senior Member
Click here to find out how to become a paid up member
 
Join Date: Aug 2018
Location: Middlesex
Vehicle: '97 Terrano II 2.4 Xtreme
Posts: 368
Default

No vice?
Wallace is offline   Reply With Quote
Old 31-12-2018, 00:30   #15
solarman216
Off road maniac
Click here to find out how to become a paid up member
 
solarman216's Avatar
 
Join Date: Dec 2009
Location: Bexhill on Sea
Vehicle: Y60 Patrol Me, 3 ltr Mrs
Posts: 17,431
Default

No but I will have some power sockets for charging my multitude of battery tools, as I am very forgetful and often leave batteries and chargers in customers premises, hope this will get round that, and I have big vice on bench in barn, Rick
__________________
Ex banger racer now off road maniac
Lokka on the front with manual hubs
Diff lock on rear
3 inch SS straight through exhaust
Manly winch bumper with 13000 lb winch
10 spike ground anchor, with multiple straps and blocks
Super strong body cills capped with scaffold pole
20% stronger springs all round
aggressive off road tyres on wheels so just swap.
Aim to get stuck and be completely self sufficient in extraction, love getting muddy, 2ft deep is good but rare.
solarman216 is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


All times are GMT +1. The time now is 18:39.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Images online photo albums