I want one of these

jonela · 20-07-2014, 11:31

All you peeps who are good at fabrication,how hard would it bee to make one of these

I would love one in my garden

http://www.youtube.com/watch?v=HQsx7sgshlM

bry · 20-07-2014, 11:49

Very impressive.Shudder to think of the work involved.I reckon it is manufactured as opposed to fabricated,if you know what i mean...

cncfabs · 20-07-2014, 11:57

Doesnt look to hard to make lots of repeatable parts there would need to be well ballanced and bearings if there are any on that would need to be very free running and water proof i can see it seizing solid with a bit of rain and salt air

20-07-2014, 11:31	#1
jonela Senior Member Join Date: Dec 2011 Location: Chateaunef du Faou, France Vehicle: 2000 LWB SE+ Posts: 906	I want one of these All you peeps who are good at fabrication,how hard would it bee to make one of these I would love one in my garden http://www.youtube.com/watch?v=HQsx7sgshlM

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

20-07-2014, 11:49	#2
bry Senior Member Join Date: May 2013 Location: South Yorkshire.. Vehicle: Nissan Terrano MK 2 SE Posts: 1,757	Very impressive.Shudder to think of the work involved.I reckon it is manufactured as opposed to fabricated,if you know what i mean...

20-07-2014, 11:57	#3
cncfabs Senior Member Join Date: Sep 2009 Location: somerset Vehicle: terrano Posts: 1,947	Doesnt look to hard to make lots of repeatable parts there would need to be well ballanced and bearings if there are any on that would need to be very free running and water proof i can see it seizing solid with a bit of rain and salt air