Go Back   :::.Nissan 4x4 Owners Club.::: > General > I'm new here, please be gentle

I'm new here, please be gentle This is where you can "introduce yourself". A chance for you as a new member to say hello and for you to tell us about yourselves, your truck and your other interests.

Reply
 
Thread Tools Display Modes
Old 11-02-2014, 22:48   #16
AlexD333
Senior Member
Click here to find out how to become a paid up member
 
Join Date: Jan 2014
Location: Uk
Vehicle: 2004 Terrano 2.7 TDI
Posts: 7,847
Default

Oh no more side step jokes I told you all I've changed now

I promise i scrapped em.

Yeah my colleague had the 4.4 its a rocket, and has some lovely gadgets.

Too pretty to enjoy offroad and too pretty to be intimidating on road (would be too scared to scratch it)

Awesome tools though!
AlexD333 is offline   Reply With Quote
Old 12-02-2014, 20:27   #17
firebobby
Senior Member
Click here to find out how to become a paid up member
 
Join Date: Feb 2012
Location: South Bucks
Vehicle: Terrano 3.0 SVE 2005
Posts: 3,499
Default

Quote:
Originally Posted by trick202 View Post
Well, I've done a few days with the plucky little tractor and I like it more and more.

I have a oil light very now and then but I suspect dodgy switch supposedly fixed by dealer. I will check for oil tomorrow.

Had a little play I'm the snow tonight, but new insa Dakars have not arrived yet. Panicked a bit when I couldn't get the green 4wd light off, but some forward/reverse sorted that.

Cheers for all the well wishes.
Oil light problems on these usually result in the oil switch that sits down the drivers side of the engine, easy to do through the o/s front wheel area, there is a down load on here, showing how to do it.
firebobby is offline   Reply With Quote
Old 12-02-2014, 20:36   #18
walshie
Senior Member
Click here to find out how to become a paid up member
 
Join Date: Sep 2009
Location: High Wycombe
Vehicle: Nissan Terrano 3.0di
Posts: 165
Default

Are there 2 switches? My oil light came on and I had the switch changed but it's still on
walshie is offline   Reply With Quote
Old 12-02-2014, 20:38   #19
walshie
Senior Member
Click here to find out how to become a paid up member
 
Join Date: Sep 2009
Location: High Wycombe
Vehicle: Nissan Terrano 3.0di
Posts: 165
Default

And it's not because the oils low before anyone makes the joke!
walshie is offline   Reply With Quote
Old 12-02-2014, 20:43   #20
briggie
Senior Member
Click here to find out how to become a paid up member
 
Join Date: Mar 2010
Location: peoples democratic republic of west yorkshire
Vehicle: " alice "
Posts: 10,473
Default

eyup
briggie is offline   Reply With Quote
Old 12-02-2014, 21:22   #21
rakerman
Member
Click here to find out how to become a paid up member
 
Join Date: Dec 2010
Location: Scotland
Vehicle: Terrano 3.0d commercial
Posts: 70
Default

Quote:
Originally Posted by walshie View Post
Are there 2 switches? My oil light came on and I had the switch changed but it's still on
Hi Walshie, yes there's 2 switches a high and a low pressure. Have a look in the downloads section for some pics where to find the high pressure switch and the part number for the switch with an extension if yours hasn't had the updated part already. When I needed one I had to give them the part no. for it as it wasn't linked to the old one on the dealers parts system.
rakerman is offline   Reply With Quote
Old 13-02-2014, 00:13   #22
trick202
Junior Member
Click here to find out how to become a paid up member
 
Join Date: Feb 2014
Location: West Yorkshire
Vehicle: Terrano Sport LWB 3.0di
Posts: 6
Default

When I bought the car they said they were fitting a new switch. He showed me the right hand side of the block as you look in the bonnet. Very easy to get to.

Oil level fine. Light comes on at startup sometimes and stays on. Other times, stays off for the whole journey.

Loving this little tractor more and more. Would love a taller centre arm rest though.

New tyres tomorrow!

Also, is door hinge/drop common?

Oh, and when are belts done? Or is this chain/gears?
trick202 is offline   Reply With Quote
Old 13-02-2014, 00:38   #23
Barrbeast
Senior Member
Click here to find out how to become a paid up member
 
Join Date: Mar 2013
Location: Dundee, Scotland
Vehicle: 1990 4.2 SWB Safari
Posts: 2,615
Default

Right, oil switch first... sounds like the muppets changed the low oil pressure switch instead of the high pressure switch (which is what they should have changed and is on the other side of the engine )

Low pressure switch is VERY easy to get to (especially if you remove the oil filter), high pressure switch failure on the zd30 is just one of those things but apparently not too bad to replace on the Terrano, but on the Trol it's a bugger and pretty much an engine out job ...

... which is why I fitted an oil pressure gauge instead (tee piece with sender into the low pressure point) and just give the oil pressure light the finger when it comes on When I get a minute I will be pulling the dash bulb!

As for the engine timing, the 3.0 is a hybrid chain/gears - camshafts run off chain driven from the front of the injector pump but everything else is gear driven. Aussie consensus is chain shouldn't need replaced
Barrbeast is offline   Reply With Quote
Old 13-02-2014, 00:51   #24
rayf3262
Senior Member
Click here to find out how to become a paid up member
 
rayf3262's Avatar
 
Join Date: Nov 2009
Location: Norfolk, Poringland NR14
Vehicle: Terrano 3.0 SVE 2002
Posts: 1,549
Default

Quote:
Originally Posted by Barrbeast View Post
When I get a minute I will be pulling the dash bulb!
Rather than ditch the dash light, consider pulling the connection from the HP switch and ground it, then the LP switch/light combination should operate normally...
__________________
Remember what the dormouse said:
Feed your head....
rayf3262 is offline   Reply With Quote
Old 13-02-2014, 12:37   #25
Barrbeast
Senior Member
Click here to find out how to become a paid up member
 
Join Date: Mar 2013
Location: Dundee, Scotland
Vehicle: 1990 4.2 SWB Safari
Posts: 2,615
Default

Quote:
Originally Posted by rayf3262 View Post
Rather than ditch the dash light, consider pulling the connection from the HP switch and ground it, then the LP switch/light combination should operate normally...
That's an idea! Cheers Ray.

Will just depend on how easy I can get at the HP switch to identify the cable and remove the connector as it's pretty crowded down there and I want to make sure I'm messing with the right thing! I can see me getting the video endoscope out...
Barrbeast is offline   Reply With Quote
Old 13-02-2014, 19:27   #26
firebobby
Senior Member
Click here to find out how to become a paid up member
 
Join Date: Feb 2012
Location: South Bucks
Vehicle: Terrano 3.0 SVE 2005
Posts: 3,499
Default

Quote:
Originally Posted by walshie View Post
Are there 2 switches? My oil light came on and I had the switch changed but it's still on
Which one did you change??
I changed the high pressure switch, drivers side and it's been fine since.....wood! wood! I need to touch some wood
firebobby is offline   Reply With Quote
Old 15-02-2014, 23:05   #27
trick202
Junior Member
Click here to find out how to become a paid up member
 
Join Date: Feb 2014
Location: West Yorkshire
Vehicle: Terrano Sport LWB 3.0di
Posts: 6
Default

Ok.
I ordered a new, taller armrest from a company in Italy. I'll post pics when it gets here and when I figure out how.
I also got my insa Dakars fitted to the car. They look great (to me) And aren't as noisy as I'd expected.
trick202 is offline   Reply With Quote
Old 16-02-2014, 00:21   #28
davenclaire
Senior Member
Click here to find out how to become a paid up member
 
Join Date: Dec 2010
Location: south east
Vehicle: terrano 2 lwb
Posts: 816
Default

Quote:
Originally Posted by trick202 View Post
Well, I've done a few days with the plucky little tractor and I like it more and more.

I have a oil light very now and then but I suspect dodgy switch supposedly fixed by dealer. I will check for oil tomorrow.

Had a little play I'm the snow tonight, but new insa Dakars have not arrived yet. Panicked a bit when I couldn't get the green 4wd light off, but some forward/reverse sorted that.

Cheers for all the well wishes.
welcome mate. instructions on opperating the 4x4 gears are on the drivers sun visor you usually have to reverse a few meters to dissengage it and the light to go out
davenclaire is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


All times are GMT +1. The time now is 03:36.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Images online photo albums