Wanted: Rear load sensing valve

eionmelrose · 03-07-2013, 18:09

Hi i have a nissan patrol gr, 2002, and am looking for the above if anyone can help. Many thanks. Eion:

makeitfit · 03-07-2013, 18:50

Fat chance

they're a tad on the pricey side from the stealers. About 400 quid plus I seem to remember .
S/H ones probably goosed too. That said give Nissan1st a ring in Welshpool
OR in theory you can strip it and rebore it and fit new seals. I couldn't find anyone doing a service kit for it so binned mine for a manual bias valve. £45 cheap as chips

Deano400 · 03-07-2013, 19:48

I don't know if there are any alternatives and I don't know exactly what your load sensing valve looks like, but this looks very similar to the pics of the valve in the Y60 workshop manual and pics on google of Y61 LSV's.

It's off an L200, but it came up when I googled nissan patrol load sensing valve.

Sometimes vehicle manufacturers use the same components from external suppliers. Of course you would have to check it's suitability.

Similar type vehicle, similar weight. But before anyone points it out, I know it's a bit of educated guesswork on suitability and I'm not advocating using incorrect parts etc etc.

http://www.ks-international.com/inde...roduct_id=1604

03-07-2013, 18:09	#1
eionmelrose Junior Member Join Date: Jul 2013 Location: scotland Vehicle: nissan patrol gr Posts: 1	Wanted: Rear load sensing valve Hi i have a nissan patrol gr, 2002, and am looking for the above if anyone can help. Many thanks. Eion:

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

03-07-2013, 18:50	#2
makeitfit Senior Member Join Date: Apr 2008 Location: on the beach WEST WALES Vehicle: Maverick TDi BLACK mmm Posts: 15,136	Fat chance they're a tad on the pricey side from the stealers. About 400 quid plus I seem to remember . S/H ones probably goosed too. That said give Nissan1st a ring in Welshpool OR in theory you can strip it and rebore it and fit new seals. I couldn't find anyone doing a service kit for it so binned mine for a manual bias valve. £45 cheap as chips

03-07-2013, 19:48	#3
Deano400 Senior Member Join Date: Dec 2012 Location: North West Vehicle: Patrol Y60 Posts: 217	I don't know if there are any alternatives and I don't know exactly what your load sensing valve looks like, but this looks very similar to the pics of the valve in the Y60 workshop manual and pics on google of Y61 LSV's. It's off an L200, but it came up when I googled nissan patrol load sensing valve. Sometimes vehicle manufacturers use the same components from external suppliers. Of course you would have to check it's suitability. Similar type vehicle, similar weight. But before anyone points it out, I know it's a bit of educated guesswork on suitability and I'm not advocating using incorrect parts etc etc. http://www.ks-international.com/inde...roduct_id=1604