|
The Clubs Virtual Pub For general chat, so come on in and pull up a chair. |
|
Thread Tools | Display Modes |
|
17-01-2015, 15:59 | #1 |
Senior Member
Join Date: Aug 2008
Location: Devizes Wiltshire
Vehicle: Nissan Note Ntec 1.5
Posts: 14,138
|
wet floors
Just seen ive got wet floor drivers and passengers front foot well
Any normal places to look? |
17-01-2015, 16:31 | #2 |
Senior Member
Join Date: May 2013
Location: Northumberland
Vehicle: Terrano 2.7TDI SE LWB
Posts: 3,604
|
Sunroof drains would be the first place to check I would think as it's both sides
|
17-01-2015, 16:58 | #3 |
Senior Member
Join Date: Mar 2010
Location: peoples democratic republic of west yorkshire
Vehicle: " alice "
Posts: 10,473
|
bulkhead , sunroof drains , sunroof , door seals , under carpets , heater matrix ......
|
17-01-2015, 17:48 | #4 |
Senior Member
Join Date: Jun 2010
Location: Resident in Bristol, Terrano in Spain
Vehicle: 1994 Terrano 2.7TD SWB
Posts: 1,398
|
Found mine had a wet floor on the drivers side two weeks ago, went straight to the sunroof drain, pipe was off! Pushed back on, job done - seemples!
|
17-01-2015, 19:10 | #5 |
Senior Member
Join Date: Aug 2008
Location: Devizes Wiltshire
Vehicle: Nissan Note Ntec 1.5
Posts: 14,138
|
Where are sun roof drains
|
17-01-2015, 19:40 | #6 |
Senior Member
Join Date: Sep 2004
Location: UK
Posts: 12,965
|
Think you have to look behind head lining to see the sunroof frame, think theyre at the two front corners
|
17-01-2015, 20:07 | #7 |
Senior Member
Join Date: Jun 2010
Location: Resident in Bristol, Terrano in Spain
Vehicle: 1994 Terrano 2.7TD SWB
Posts: 1,398
|
Unscrew the sun visor after prying off the screw cover with a small screwdriver, unscrew the grab handle after removing the screw cover plates, again with a small screwdriver, unscrew the sun visor retaining clip, then pull down the door seal about a foot from the corner each way.
Gently pull down the head lining and you will see the corner of the sunroof with it's spigot. This should have a piece of tubing about 10mm in diameter on it. If it doesn't there's your problem. Mine was about 1" away from the spigot - I just pulled it up a bit and pushed it back on. |
|
|