|
The Clubs Virtual Pub For general chat, so come on in and pull up a chair. |
|
Thread Tools | Display Modes |
|
30-10-2015, 11:04 | #1 |
Senior Member
Join Date: Aug 2014
Location: Dorset
Vehicle: highly modded Terrano 2
Posts: 1,088
|
drainage under windscreen
Are there drain plugs or any thing under wind screen as I'm getting water dripping in passenger foot well where fan join pollen filter on my 2002 Terrano
Just thought id ask be for removing scuttle panel |
30-10-2015, 11:13 | #2 |
Senior Member
Join Date: Sep 2004
Location: UK
Posts: 12,965
|
Theres a access plate at the passengerside under the scuttle panel. Needs removing, cleaning and sealing. Heard of it loads of times and my 05 plate had the issue but must of been happening for ages because it ruined the bearings on the blower.
So remove those pesky wiper arms and then the plastic scuttle and you'll see the panel. I lubed the wiper pivots at the same time to stop squeaks. |
30-10-2015, 11:18 | #3 | |
Moderator
Join Date: Jul 2012
Location: West Midlands
Vehicle: 04 2.7 SWB Terrano II Van
Posts: 13,526
|
Quote:
My heater seems to squeek a little on setting 2 for some reason
__________________
Moderator 04' Terrano II SE 2.7 TDi SWB Commercial in Silver - Project Thread Toyo Open Country M/T 33's on 10J Steels, Super Strong Steering Job Navara D22 Snorkel, Front LOKKA, Maunal Hubs, EGR Blank TunitII ECU Chip, 3" Body Lift, 2" Suss Lift, Heat Exchanger Black Interior, 3.0 Borg&Beck Clutch, Eckes Heated Fuel Filter 99' Y61 Patrol GR SE 2.8 TD6 LWB in Blue/Silver - Project Thread Engine Transplant - In Progress!!! |
|
30-10-2015, 11:22 | #4 |
Senior Member
Join Date: Sep 2004
Location: UK
Posts: 12,965
|
Yep similar to mine.
Strange thing is that on my 05 plate truck when the scuttle was lifted the passenger side had the panel but the driverside didn't have a panel. Removed the scuttle on my 99 project truck and that has a panel on the driverside. Once you remove the passenger side access panel it is open straight into the heater with a small lip around the aperture. I guess another small cost saving by nissan. |
30-10-2015, 11:29 | #5 | |
Senior Member
Join Date: Feb 2007
Location: Staffordshire
Vehicle: Maverick Mk I 2.7 TD LWB
Posts: 7,825
|
Quote:
Remove plate, loads of sealant between plate and body, and even more around the screw fixings and a bit on top around the screw heads. Symptoms are... if you have rubber mats, the water is dripping onto them from above. Rustic
__________________
Ford Maverick GLX 1995 2.7TD LWB in illusion silver, 98k miles. Owned since new, for 22 years. Best car I have ever owned. Just wish I could drive it more. |
|
30-10-2015, 11:47 | #6 | |
Senior Member
Join Date: Aug 2014
Location: Dorset
Vehicle: highly modded Terrano 2
Posts: 1,088
|
Quote:
|
|
30-10-2015, 11:50 | #7 |
Senior Member
Join Date: Sep 2004
Location: UK
Posts: 12,965
|
Nah the agro is removing those wiper arms
Took Bigbunny ages to remove on my 05 plate but my 99 project took seconds. When I refitted both they got a smear of copper slip on the splines But yeah these forums are great and have to say of all the forums I'm a member of this one has been the most helpful by far |
30-10-2015, 11:56 | #8 | |
Senior Member
Join Date: Feb 2007
Location: Staffordshire
Vehicle: Maverick Mk I 2.7 TD LWB
Posts: 7,825
|
Quote:
If needed, I can post a pic later.
__________________
Ford Maverick GLX 1995 2.7TD LWB in illusion silver, 98k miles. Owned since new, for 22 years. Best car I have ever owned. Just wish I could drive it more. |
|
Thread Tools | |
Display Modes | |
|
|