at long last they are on

[exosteve]

its been a long time since I started these but today I got them on

[exosteve]

there on, the switch and wires are in but ive got nip out for a couple of bits to finish the wiring

[exosteve]

and it matches my angry bird and cb antenna

[Lincs Mav]

I do like the looks of that. Will you be making any more ightbars?

Cheers Gav

[exosteve]

Originally Posted by Lincs Mav

I do like the looks of that. Will you be making any more ightbars?

Cheers Gav

I put a post on here before I started to make this to try and get some interest going and maybe make a batch of them.
but no one was interested.
all I have now is one more part made one for me mate elty

[elty001]

Originally Posted by exosteve

I put a post on here before I started to make this to try and get some interest going and maybe make a batch of them.
but no one was interested.
all I have now is one more part made one for me mate elty

looks the biz mate

Just need to source some lights now.

My shopping list for the truck just keeps growing

[Banshee]

Originally Posted by exosteve

there on, the switch and wires are in but ive got nip out for a couple of bits to finish the wiring

How did you wire the wiring through? Have you gone through the roof?

[Sweety]

Looks great & liking your colour scheme more & more

[exosteve]

Originally Posted by Banshee

How did you wire the wiring through? Have you gone through the roof?

at first I made a loom that connected all the lights but they were as bright as candles
so I had to split them onto 2 sets of three.

the two cables fit snugly down the side of the windscreen which I still have to cable tie on. and into the engine bay fuse box. and a 30 amp relay and a posh little light up switch
next job boost gauge and turbo tweek
god I love my truck

[exosteve]

job done

[Barrbeast]

Looks awesome bud

[Banshee]

Originally Posted by exosteve

job done

Good lad!!!!! Looks superb

[rustic]

Originally Posted by exosteve

its been a long time since I started these but today I got them on

Have you put some gasket foam material, between the metal work and the roof, as it should first of all seal water out from the edges of the Riv nuts, and also help to prevent the metalwork from scratching the paint work, which could cause the area to rust.


Re the cables, what you could have done was run the cables into the tube lighting bar, then drilled holes in the roof, fitted grommets, and sealed it with the foam gasket.
The holes for the cables would have been hidden by the metal base plates of the lighting bar. Result, no external wires, no leaks..

[exosteve]

I just put a load of silicone around the rivnuts. put lots around the edges as there was quite a gap.
and I prefer the cables accessable for maintainance and repairs.
keep it simple