before and after

exosteve · 31-05-2013, 21:27

before todays work.....

exosteve · 31-05-2013, 21:33

after the 2" body lift.
it feel big now...
cant wait get my wheels now.
took all day long to do this lift.
and cheers lads you could of warned me what I work I was taking on.
I never even considerd the fact that the bumpers are are attatched to the chassis not the body.that was a fair old conversion so theres no 2" gap between them.
I never thought about the gear stick being a bit further away.
And what do I do about the rubber seal around the intercooler as theres a 2" gap?
happy though

96terrano · 31-05-2013, 21:42

when you've undone all the bolts, how do you lift the body to fit the spacers? do you just eat loads of spinach like popeye

exosteve · 31-05-2013, 21:57

block of wood under the sill and a jack. I was sure summat was going to break.
glad its behind me

stinka · 31-05-2013, 21:58

Gap to Intercooler is no problem mate, makeitfit has no rubber on his at all

Looks well tho mate

how did u make the bumpers work ?

exosteve · 31-05-2013, 22:08

angle grinder and welder.
redrill holes on front bumper only one pin will fit so had to make a clamp for the bottom pin.
the rear brackets that fit into the chassis were removed and re welded in raised position.

stinka · 31-05-2013, 22:12

Spot on. Toying with the idea of doing body on mine but no need this far

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

31-05-2013, 21:42	#3
96terrano Senior Member Join Date: Jun 2010 Location: Dumfries and Galloway, Scotland Vehicle: Nissan Terrano 2.7TD LWB Posts: 8,024	when you've undone all the bolts, how do you lift the body to fit the spacers? do you just eat loads of spinach like popeye

31-05-2013, 21:57	#4
exosteve Senior Member Join Date: Dec 2012 Location: stoke on trent Vehicle: 2001 2.7 td lwb terrano Posts: 2,740	block of wood under the sill and a jack. I was sure summat was going to break. glad its behind me

31-05-2013, 21:58	#5
stinka Senior Member Join Date: Feb 2012 Location: Staffs Vehicle: '02 Terrano TDI sport lwb Posts: 3,787	Gap to Intercooler is no problem mate, makeitfit has no rubber on his at all Looks well tho mate how did u make the bumpers work ?

31-05-2013, 22:08	#6
exosteve Senior Member Join Date: Dec 2012 Location: stoke on trent Vehicle: 2001 2.7 td lwb terrano Posts: 2,740	angle grinder and welder. redrill holes on front bumper only one pin will fit so had to make a clamp for the bottom pin. the rear brackets that fit into the chassis were removed and re welded in raised position.

31-05-2013, 22:12	#7
stinka Senior Member Join Date: Feb 2012 Location: Staffs Vehicle: '02 Terrano TDI sport lwb Posts: 3,787	Spot on. Toying with the idea of doing body on mine but no need this far