For sale/swap/terranno 2.7tdi intercooler model

[kwackernut]

Hi,would anyone be intrested in taking on a troubled 4x4,its a 1998 terrano 2.7tdi touring,taxed for six months,mot for 11 months, its very tidy,has all the whistles and bells,tow bar,4 new runway enduro tyres,everthing works,only problem is it keeps going into limp mode when it warms up.nobody seems to know why,everyone i knows had a look,but i still cant get it to go properly,it drives ok,but snails overtake me,so ive decided to let it go,who knows,someone else may have the answer,but its going cheap,make me an offer,would consider a 4x4 which needs work,as long as its runs right lol,call me on 07795 599919, many thanks,andy.

[(RIP) PLANK]

I am sure there will be a few answers to this on here! You may be better of just fixing the one you have

[kwackernut]

You may be right,its driving me nuts,its a cracking motor,the engines great when it first starts,goes like a rocket,but it just keeps diying on me !!!,im pulling my hair out,we have replaced nearly all the sensors etc,run out of ideas lol

[stinka]

Originally Posted by kwackernut

You may be right,its driving me nuts,its a cracking motor,the engines great when it first starts,goes like a rocket,but it just keeps diying on me !!!,im pulling my hair out,we have replaced nearly all the sensors etc,run out of ideas lol

What sensors ? and did u use genuine parts ? ?

these 2 sensors for the temp, the large one being the ecu one

[kwackernut]

Hi, we replaced the ecu temp sender with a new one,got it from millner 4x4,and replaced the air mass sensor,as that came up on the fault code,its got a bosch system on it,but mine unusual,as it has no egr valve fitted.

[stinka]

Originally Posted by kwackernut

Hi, we replaced the ecu temp sender with a new one,got it from millner 4x4,and replaced the air mass sensor,as that came up on the fault code,its got a bosch system on it,but mine unusual,as it has no egr valve fitted.

So the maf ? where did u get it from ??

[briggie]

crankshaft position sensor ( ckp )

[kwackernut]

Thanks briggie,thats the only bit we have not replaced,only due to the cost,need to re mortgage the house to buy one lol,will give it one last ditch try,many thanks for all your help guys,will keep you posted,andy.

[stinka]

Originally Posted by briggie

crankshaft position sensor ( ckp )

aye, this as well

But u need the codes read with a proper consult, no pint just chucking all your money at it replacing everything.

boost leaks are dead common and produce this fault

[stinka]

Have you done the maf ? did you use a genuine one from nissan ?

[kwackernut]

Thanks stinka,i need to look at this from a different prospective,i will take it to nissan,and get the codes read properly,it would be a shame to bin it,as its in such good nick.will get pro advice,and start afresh.

[stinka]

Have you been to nissan to get the fault codes read properly with consult 2 ?

Should cost £30

post fault codes here and well tell you what it is.

I had this on mine btw, it was a dodgy maf sensor.

other things are throttle pedal, split intercooler or boost pipes, leaking inlet manifold gasket or throttle housing, egr valve stuck open, injector no1 needle lift sensor.

But like i say get the fault codes off first and let us know

[kwackernut]

Many thanks for the info,you have been more help than anyone i know,will keep in touch,and report on findings,many thanks once again,andy

[briggie]

Originally Posted by kwackernut

Hi,would anyone be intrested in taking on a troubled 4x4,its a 1998 terrano 2.7tdi touring,taxed for six months,mot for 11 months, its very tidy,has all the whistles and bells,tow bar,4 new runway enduro tyres,everthing works,only problem is it keeps going into limp mode when it warms up.nobody seems to know why,everyone i knows had a look,but i still cant get it to go properly,it drives ok,but snails overtake me,so ive decided to let it go,who knows,someone else may have the answer,but its going cheap,make me an offer,would consider a 4x4 which needs work,as long as its runs right lol,call me on 07795 599919, many thanks,andy.

theres a clue

[briggie]

either take it to nissan for the codes read ....... or do it yourself

http://www.nissan4x4ownersclub.com/d...kshop/wk29.pdf