mag - early patrol master cyl

[mag]

Hi all,

Just been searching the net for an early patrol master cylinder (4 wheel drum) and not much luck. It's 1inch bore and part number is JB1419

If anyone has one I will gladly buy and pay their membership for another year. :thumbs

[mag]

Also, shouldn't it say "non club member" rather than "none club member"?

[CaptLimey]

Hi Mag & welcome
I don't have one but have you tried Milner Off Road - 01629 734411 - www.milneroffroad dot com. (If you're former member you probably have!)
And I think you're right about the spelling it's always puzzled me!
Regards CL

[The Patrolman]

Hi all,

Just been searching the net for an early patrol master cylinder (4 wheel drum) and not much luck. It's 1inch bore and part number is JB1419

If anyone has one I will gladly buy and pay their membership for another year. :thumbs

Oh cock:eek: just spent 5mins typing a reply and pc froze:(

Here's a pic of one i have spare:thumb2 its from a 97 4.2 Petroll it looks the same as the one on my 90 Y60 4.2d troll with discs front and drums rear..

try asking milners if it's compatible with yours:thumb2

It's a good unit and was not the fault that lead me to buy a new item:doh

[The Patrolman]

Did You get sorted there are a few different types.
try this one
http://cgi.ebay.co.uk/Brand-New-Genuine-Nissan-Patrol-Brake-Cylinder-2-8TD-/230517534604?pt=UK_CarsParts_Vehicles_CarParts_SM

[mag]

Thanks for the replies folks. It seems the m/cyl I need is a very early one which predates any sold in the UK:(

I have found these are available in australia from repco and supercheap (big chain stores like halfrauds) so I will get one from them.

Many thanks for those who made suggestions

[Adz]

I'll send a pm bout "none" cock up :o :doh :lol :clap