Dirty electrics.?

[Adz]

So you have a tow bar with electrics :rolleyes:
&
You have a caravan,trailer,dolly or board :rolleyes:
You know it all works but have trouble time to time with lights not working but the bulbs are ok :rolleyes: :confused:

Well...:rolleyes:

That will be a thing of the past thanks to this top tip :augie

200ml of any brand washing up liquid.
200ml of any brand viniger.
400ml of boiled water (any brand :lol).
Place/poor all 3 into a triger bottle squiter.

Spray the terminals on both plugs then open the terminals with a flat headed screw driver & spray again till all the rubish comes out...wait 10 mins...

Spray again with luke warm water & leave to dry...

Job done :augie :clap


Nice clean terminals & no loose conection :clap


:thumbs :thumbs :thumbs :thumbs :thumbs :thumbs Hope this helps someone :thumbs :thumbs :thumbs :thumbs :thumbs :thumbs

[Deleted account DD]

:eek::eek::eek::eek::eek:


I wouldnt put that solution anywhere near anything electrical.

Corrosives, abrasives, water and electrics. Just what the doctor ordered.........not :rolleyes:


Seriously, whats wrong with wd40 especially when Aldi have had it in for just over £1 a decent sized can and I saw the generic equivalent at a show for 99p per 1/2litre aerosol.

Far easier and i've been using just that on my leccies for the past 20yrs plus with no problems :thumbs

[Adz]

Well i wont argu or say good or bad as i have just been shown it by a 50+ year old trucker whos been using it for as long as i am old... :bow
Showed me on his tractor unit which he owns & bought the copper terminals up a treat... :clap
Will try it on mine tomorrow... :rolleyes:
WD40 only acts as a water repelant not a cleaner & also acts like glue to dust... :nenau

[Deleted account DD]

WD40 cleans , the idea its just a water repellant is rubbish. From their site:


CLEANS: WD-40 gets under dirt, marks and grease making it easy to wipe away. It also dissolves adhesives, allowing easy removal of labels, tape, and stickers
PROTECTS: WD-40 protects metal surfaces with corrosion-resistant ingredients to shield against moisture and other corrosive elements
LUBRICATES: WD-40's lubricating ingredients are widely dispersed and hold firmly to all moving parts
PENETRATES: WD-40 loosens rust-to-metal bonds and frees stuck, frozen or rusted metal parts
DISPLACES MOISTURE: Because WD-40 displaces moisture, it quickly dries out electrical systems to eliminate moisture-induced short circuits. Turn the power off before you spray

http://www.wd40.co.uk/index.cfm?articleid=1519

In my experience it doesn't attract dust any more than any other product and significantly less than others.

In any case youre suggesting introducing a shed load of h2o to the electrical sockets :eek::eek: better to flush through with wd40 or similar. They dont have to be shiny to work, worrying about that could be described as anal.

I appreciate the trucker has gleamo copper terminals but I've also heard that if a woman cuts the nails of her right hand with her left hand she will have the upper hand in marriage ;) So dont tell the missus and thats probably a better policy to follow :naughty

[Adz]

:lol :lol :lol :lol :lol :lol

Will do both :thumbs

Report back tomorrow with verdict :confused:

WD40:-
I wonder how many people are as ignorant as me as i've never bothered reading the can or go to the web site :doh
Just thought it un-sticks,stuck nuts & bolts etc & acts as a water repelant :rolleyes:

Ya learn something every day...:augie

:thumbs

[Terranosaurus]

I wonder how many people are as ignorant as me as i've never bothered reading the can or go to the web site :doh
Just thought it un-sticks,stuck nuts & bolts etc & acts as a water repelant :rolleyes:


Funny thing that as a penetrant its pretty rubbish yet its the thing everyone uses it for - as a lubricant it is also pretty rubbish - the clues on the tin....

WD40 - WaterDisplacement (formula number) 40.


And of course they says those things about it on their website they are trying to sell it - you don't see it in use in many pro garages.


For freeing of rusty nuts buy specific penetrating oil it is far far beter, for general spray lubericant look for a variety with PTFE in also far far better.

But for blasting out connectors the proper stuff to use is funnily enough electrical contact cleaner, then maybe a blast of WD40 or similar and finish off with a spray grease, clear or white doesn't really matter (don't use copper grease though - its conductive) - won't attract dirt cos the flaps always closed on you vehicle electric and its best to protect the trailer plug either by putting it in one of the holders that are on modern trailer and caravans or stick it in a plastic bag and cable tie tight.

[lacroupade]

Interesting thing though - that spray grease is not good on hot places. A mechanic sprayed it on my daughters Clio on the ECU plugs (which on that pile of shite are right on the back of the cylinder head so get very hot)....within days it had dried solid and was actually conducting and causing all sorts of problems.....the proper garage I took it too had a right little wobbly about "the idiot that did this...!"....they airblasted the powdered remains of it and sprayed with electrical contact cleaner and hey presto, all fixed!

[Deleted account DD]

WD40 is the gerber multi tool of lubricants. Its reasonable at most things and affordable :thumb2

I do have various lubes & cleaners knocking around but with the likes of electrolube to pick on one (havent looked recently) being several times that of a can of wd40 , wd40 wins every time for flushing ,soaking and protecting :thumb2 it does the job.

My engineering brain is well dominated by my own tight wallet when I have to pay :lol:lol:lol

[Adz]

Should of taken a before & after :doh
Didnt think of it till it was to late :doh

Used the washing up liquid,viniger & water solution.
Within minutes,nice clean sparkling conections :eek:
Rinsed it out,followed by a quick blast of WD40 :rolleyes:
Job done.
Tested it on me trailer,alls working fine :thumbs

[ssteve]

Well i wont argu or say good or bad as i have just been shown it by a 50+ year old trucker whos been using it for as long as i am old... :bow
Showed me on his tractor unit which he owns & bought the copper terminals up a treat... :clap
Will try it on mine tomorrow... :rolleyes:
WD40 only acts as a water repelant not a cleaner & also acts like glue to dust... :nenau

well it will bring em up, it's eating them .

ssteve

[jims-terrano]

When I put towbar sockets on from new I allways fill the back terminals with ordinary grease and smear the front pins in the socket with grease too. I don't have problems with corrosion and don't suffer dirt and dust sticking to them either. Be warned using grease or any other lubricant, modern tow hitch type stabilisers do not work when contaminated with oils and grease.

Jim T

PS my sockets now mounted on the rear bumper:thumbs

[Adz]

When I put towbar sockets on from new I allways fill the back terminals with ordinary grease and smear the front pins in the socket with grease too. I don't have problems with corrosion and don't suffer dirt and dust sticking to them either. Be warned using grease or any other lubricant, modern tow hitch type stabilisers do not work when contaminated with oils and grease.

Jim T

PS my sockets now mounted on the rear bumper:thumbs

Thats where mines going :thumbs Eventually :augie

[ssteve]

When I put towbar sockets on from new I allways fill the back terminals with ordinary grease and smear the front pins in the socket with grease too. I don't have problems with corrosion and don't suffer dirt and dust sticking to them either. Be warned using grease or any other lubricant, modern tow hitch type stabilisers do not work when contaminated with oils and grease.

Jim T

PS my sockets now mounted on the rear bumper:thumbs

i find the battery terminal spray is good in the rear of plugs/sockets

ssteve

[Adz]

i find the battery terminal spray is good in the rear of plugs/sockets

ssteve


Didn't know there was a "battery terminal spray" available :eek:
Always used Vaseline :rolleyes:

[Terranosaurus]

Didn't know there was a "battery terminal spray" available :eek:
Always used Vaseline :rolleyes:

Yes but what do you put on you battery terminals.

[lacroupade]

Yes but what do you put on you battery terminals.

:jesterbg:jump

[Adz]

Yes but what do you put on you battery terminals.


:doh

:clap

:lol :lol :lol :lol :lol

[rossco]

A simple solution to the trailer sockets is to have 2 female connections.
One on the vehicle and one on the trailer.

When not in use the flap closes over the connections and hey presto no water or crap can get into them when left parked up outside.

I use a length of wiring loom with the male connection at each end and they plug into to each female when I need to use the trailer.

This is the same as what happens on the rental trailers here,sort of as deterrent to stopping them from being used unofficially as they hold on to the leads when the trailer is not on hire

[Deleted account DD]

That seems a clever scheme rossco to stop ad hoc use :thumb2

However all this talk of doing this that and the other, once youve done a decent installation job or your caravan/trailer electrics are servicable, why not just leave them alone? make sure when (not if when) moisture gets in it can get out. On our last two vans and this one the trailer electrics pushed into a reccess in the fairing. that held them pointing downwards with a drain hole at the bottom. Make sure everything in there is sprayed with something like .....dare I say it.....wd40...the little red tube will get you access into all parts of it.

Its cost you a quid and 20 minutes once a year and personally I've not had any corrosion related electrical connector problems in 20yrs plus other than my first van which had the then single connector wrapped in a plastic bag with neatly sealed in dampness and corroded to hell when I got it.

And as far as worrying if the pins are shiny , wellllll.................


:jesterbg:jesterbg


;)

[lacroupade]

A simple solution to the trailer sockets is to have 2 female connections.
One on the vehicle and one on the trailer.

When not in use the flap closes over the connections and hey presto no water or crap can get into them when left parked up outside.

I use a length of wiring loom with the male connection at each end and they plug into to each female when I need to use the trailer.

This is the same as what happens on the rental trailers here,sort of as deterrent to stopping them from being used unofficially as they hold on to the leads when the trailer is not on hire

not to mention the sheer satisfaction.....:augie:naughty

[ssteve]

Didn't know there was a "battery terminal spray" available :eek:
Always used Vaseline :rolleyes:

you need to get out more

ssteve

[ssteve]

A simple solution to the trailer sockets is to have 2 female connections.
One on the vehicle and one on the trailer.

When not in use the flap closes over the connections and hey presto no water or crap can get into them when left parked up outside.

I use a length of wiring loom with the male connection at each end and they plug into to each female when I need to use the trailer.

This is the same as what happens on the rental trailers here,sort of as deterrent to stopping them from being used unofficially as they hold on to the leads when the trailer is not on hire

this is also usefull for people who keep nipping or driving off with plug in , just fit a new link lead and off you go!!! the unauthorised use thing, nah can make one up in 10 mins

ssteve

[jims-terrano]

this is also usefull for people who keep nipping or driving off with plug in , just fit a new link lead and off you go!!! the unauthorised use thing, nah can make one up in 10 mins

ssteve

There speaks a man of experience:lol

Jim T

[lacroupade]

There speaks a man of experience:lol

Jim T

also guilty here! :o:o:o

[jims-terrano]

also guilty here! :o:o:o

I'd never do a thing like that either:o:o:o

Jim T

[lacroupade]

I'd never do a thing like that either:o:o:o

Jim T

what a bunch of losers we are! :doh :lol:lol:lol

[rossco]

It's a bit like the old saying:

"Glass is only for honest people" ;)

[lacroupade]

It's a bit like the old saying:

"Glass is only for honest people" ;)

we'll add you to the list as well then rossco! :lol:lol

[DJ38]

this is also usefull for people who keep nipping or driving off with plug in , just fit a new link lead and off you go!!! the unauthorised use thing, nah can make one up in 10 mins

ssteve

10 minute eh? then 15 hours flight to new zealand!!

[tezzer]

i dont know what all the fuss about corrosion is, it costs less than a fiver for two sockets, and 10mins to change them, so change them every year if they look dodgy, no big deal really. and if you wrap them in a plastic bag you are asking for trouble. :doh

[Deleted account DD]

i dont know what all the fuss about corrosion is, it costs less than a fiver for two sockets, and 10mins to change them, so change them every year if they look dodgy, no big deal really. and if you wrap them in a plastic bag you are asking for trouble. :doh

Bang on :thumb2 though annual change seems too much like hard work...........I can knacker a socket by handling it never mind de wiring it :):lol:lol:lol

[Jocky]

Could always clean it with HP Sauce:augie Leave it on for 5 mins and rinse with water, brings it up like new:thumbs If you don't believe me try it:clap

Wonder what that HP Sauce does to your guts;)

[Adz]

Could always clean it with HP Sauce:augie Leave it on for 5 mins and rinse with water, brings it up like new:thumbs If you don't believe me try it:clap

Wonder what that HP Sauce does to your guts;)


The same as curry...
Toilet...
Smell...
All cleaned out & ready for the next night out :lol