Terrano ll SE+ Auto Y reg 2001 Parts

[Clive S]

In 2010 I bought one of these which I am still using and is running well. At the same time I bought an identical one same colour and even sequential VIN number which I took apart for spares and stored. I have used the auto box. All other major components, transfer box, axles, prop shafts, engine, doors, electrics and components including ECU are available. I now need the space this all takes up and even thinking maybe I will sell my running one and get an X-Trail. Open to reasonable offers for any of the parts I have. Engine is complete with aircon compressor etc and except for the alternator is as was when I dismantled the doner vehicle. I have had the duff alternator overhauled but not refitted it. Many other parts eg: exhaust. If you need something, ask. I may have it. No instrument panel as I used that as well.

[arcascomp]

Have you got a timing control module? (fits immediately above the fusebox under the drivers dash)? PM me a cost to post to Edinburgh if you do please. Also my passenger side rubber inner wing thing has burst it's poppers and now dangles a bit close to moving parts, was just going to cut it away, but might replace if it doesn't cost too much.

What about gay aircon pipework? The bit that runs down the front near the radiator burst on mine a few months back and had a bit of green arterial spray out the front of the car when I parked up - I've never got round to getting it fixed, but while you are costing bits up....

A rust free body would be nice too! :-)

[Lazy-Ferret]

I am after a light gray interior light, the one that goes in the middle of the roof, just behind the sunroof, if you have one, as someone, before I got it, put a larger bulb in mine, and plastic has melted and gone so brittle it's just crumbling apart.:thumb2

[Clive S]

Soryy, did not keep roof lining or light.

[Clive S]

Hi arcascomp. Not sure if I have timing module or not, would need more info as I did not know they had one. Inner wing skirts were shot on both of mine so just bought new ones from Nissan. I have all aircon pipes in good order. Private message me for more details and contact, I am new here and if I am honest struggling a bit getting round the forum and putting replies in the right place.

[perelaar]

Hi Clive
I'm looking for the chassis crossmember supporting the gearbox, and for a brake reservoir cap.
For the crossmember, see a part diagram here (http://i1373.photobucket.com/albums/ag373/perelaar/dwarsbalk%20chassis%20Terrano_zpsd3l7xb7b.jpg) (the yellow part) and a picture from the one on my T2 here (http://i1373.photobucket.com/albums/ag373/perelaar/IMG_2885_zpsargaagro.jpg).

Note: I'm living in Belgium (will of course pay the transport costs!)

[Clive S]

Hi perelaar. Sorry bare chassis has now gone complete. Yes I do have he brake reservoir cap if you want it. Send private message to arrange postage. Clive.

[papin]

Hi, have you got a starter motor and will it fit to 1997 please?

[briggie]

jims terrano might need some bits :thumb2

[rickydicky]

If it's a diesel will the fuel tank fit my 1997 lwb and if you have one of course !?

Thanks

[Clive S]

Hi rickydicky. Yes it would have but its already gone. Sorry

[Clive S]

Hi Papin. If its the same as a 2001 (auto) then yes I have but as the engine is complete with all accessories and ready to go I would rather not start to selling off sub assemblies from it yet. I am guessing that starters for manual and autos have differences anyway. I think there will probably be a lot of people on here that would be able to answer that.

[solarman216]

As far as I know all the diesel starters are the same up to 99, (nacelle type) petrols and jonellas in france are flat faced, so after 99 there may be differences, , I have not tried a flat face in a nacelle type but see no reason why it should not be OK as the flywheel is in the same place, Rick

[clivvy]

do you have the rear door? And is it the "square" type, i.e. the glass is one square piece rather then the offset bit....

I am looking to get a decent rear door to re-spray as I dented mine somewhat....

I would have to collect though, not sure where you are!:thumbs

[Clive S]

Yes I do. Both sides, which do you want, I am in Essex. PM me for contact details if you want one.

[Banshee]

Oh damn!!!!! I forgot about this thread!!!!!

I need some parts please, is this a Square Headlight Mk4 like mine?

If so I'm looking for;

Rear Drivers Bumper Light (Complete Unit)
Speedo - Is yours digital? If so whats the mileage on the clock?

[clivvy]

Yes I do. Both sides, which do you want, I am in Essex. PM me for contact details if you want one.

cheers chap, I wont mess you about, Essex is probably too far for me unfortunately!

[briggie]

cheers chap, I wont mess you about, Essex is probably too far for me unfortunately!

im going to Norfolk in a couple of weeks clive if he wants to meet me half way , I can pick them /it up for you :thumb2

[John-Szostak]

Hi Clive,

Do you happen to have the airvents/stereo surround?

Ta.

[Clive S]

Hi John. Yes I think I do, but cannot confirm today. All the small parts like that are stored at a friends and I will need to go there or ring him to confirm. If I have then it is the artificial wood grain type if that is what you after, Clive.

[Clive S]

Happy for anyone to call by and collect if that helps. Clive S

[Clive S]

im going to Norfolk in a couple of weeks clive if he wants to meet me half way , I can pick them /it up for you :thumb2
Happy for anyone to call by and collect pretty much anytime if that helps. Clive S

[John-Szostak]

Hi John. Yes I think I do, but cannot confirm today. All the small parts like that are stored at a friends and I will need to go there or ring him to confirm. If I have then it is the artificial wood grain type if that is what you after, Clive.

That would work Clive (as long as its cheap)!

I have a project in mind that would ruin the wood effect anyway!

[Paff]

Clive - I did PM you twice about the roller luggage cover. Do you still have it?

[Clive S]

Hi Paff. Got 5 PM from you but all about front wings only. Sorry the breaker did not come with the roller you require anyway.

[Cobblers_uk]

Hi do you have the lower rear light lens? The near side one from the bumper that has the reverse light in it? Thanks.