My New Terrano

[jims-terrano]

Bought myself a new truck, pick her up later this week :thumbs

Some bits of surface rust in the arches but nothing major, could leave them but I'm OCD so they'll be getting treated. Want to fit some roof rails too.

[jonela]

Ooooooo! Nice!:thumb2

[Lazy-Ferret]

Very Nice

[larson]

i like it jim:thumb2 please treat it underneath:augie

[ian's terrano]

looks good :clap:clap

[zippy656]

Would love a swb one.for fun

[jims-terrano]

Would love a swb one.for fun

So would I but I got a LWB instead :lol:lol:lol:lol:lol

[zippy656]

So would I but I got a LWB instead :lol:lol:lol:lol:lol

Me.too


But a toy would be nice :naughty

[briggie]

looks nice jim ..... yours or the bosses ? :augie

[terrano bob]

:clap :thumbs

[jims-terrano]

looks nice jim ..... yours or the bosses ? :augie

Depends if I speak nicely to her :thumbs

[spinna]

Looks really smart :)


Sent from my iPhone using Tapatalk

[larson]

i guess that means you put the old one in against this and no longer need the sills welding...

[jims-terrano]

Nope still got the old one. Not decided what to do with it just yet. Need to get the plates transferred over too which takes a few weeks apparently. Ns sill needs a plate. Will probably offer it on here and take it from there. As you know pretty mush all the rot spots are sorted, 4 good tyres so should be a good buy. Not sure if I should keep it and flog the little car.

[makeitfit]

Jim it looks a dandy BUT do not take it for granted it's only a bubble or two :o
I'm right in the middleof the Black Pearl renovation and I promise you there will be bits of it fizzing away right now. There are so many flippin' little holes every where for trim and plastic and who knows what :doh
So if it's a keeper, set to and treat and seal it bit at a time.
Good luck , enjoy :D

[jims-terrano]

Oh yes the old wire brush and wax oil will be used in abundance. I guess it means you are all stuck with me for a few more years :doh

[Bigbunny2007]

looks a nice truck mate :thumb2

[clivvy]

looking good JIm, cant wait to see it!

As MakeItFit says, better give it a good going over. I suggest removing the sill kick plates, and pumping some waxoyl in that way (im sure its been mentioned on here before) and that my plan also.:thumbs

[jims-terrano]

looking good JIm, cant wait to see it!

As MakeItFit says, better give it a good going over. I suggest removing the sill kick plates, and pumping some waxoyl in that way (im sure its been mentioned on here before) and that my plan also.:thumbs

Got to be careful the drain holes don't get blocked. Think lolly sticks were mentioned weren't they.

Trouble is I'm going to be sad to finally see my old truck go when it finally does.

[Sweety]

Very nice Jim:thumbs you must like blue T2's:lol

[clivvy]

Got to be careful the drain holes don't get blocked. Think lolly sticks were mentioned weren't they.

Trouble is I'm going to be sad to finally see my old truck go when it finally does.

yup, but when you have finished spraying, you poke out the drain holes then should be ok..! besides, I think its a solution waiting to be found - im going to figure one out for mine because I don't want to go down the same route as the Maverick.

[jims-terrano]

Very nice Jim:thumbs you must like blue T2's:lol

I just like T2's :lol

[Dynamics]

Well done, nice truck that.

The first job will be to lift that saggy front end!

Brian.

[judd750]

Well done, nice truck that.

The first job will be to lift that saggy front end!

Brian.

reindexing torsion bars ?

i`m your man just done two t2`s got arms like popeye now !!!
no wd 40 left and my wire brush has no bristles left after cleaning the threads off the adjusting bolts :doh
once threads are clean its happy days :clap

don`t have to take the circlips off , just jack the wishbone up a bit,
just wiggle and pull,
turn up two splines happy days

[briggie]

chuffed for ya jim mate , its about time you had some good fortune , I hope it brings you lots of fun :thumb2